Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
3-5
3
If any of those circuits are defective, the
engine trouble warning light will come
on and the clock display will indicate a
two-digit error code (e.g., 11, 12, 13).
If the clock display indicates such an er-
ror code, note the code number, and
then have a Yamaha dealer check the
vehicle.
CAUTION:
ECA11540
If the clock display indicates an error
code, the vehicle should be checked
as soon as possible in order to avoid
engine damage.
EAU12343
Handlebar switches
Left
Right
EAU12400
Dimmer switch “ / ”
Set this switch to “” for the high
beam and to “” for the low beam.
EAU12430
Turn signal switch “ / ”
To signal a right-hand turn, push this
switch to “”. To signal a left-hand
turn, push this switch to “”. When re-
leased, the switch returns to the center
position.
Since this model is equipped with a
self-canceling system, the turn signal
lights will self-cancel after the vehicle
has traveled both about 150 m (490 ft)
and for approximately 15 seconds.
However, the turn signal lights can also
be canceled manually by pushing the
switch in after it has returned to the cen-
ter position.
NOTE:
The self-canceling system only oper-
ates when the vehicle is moving, so that
the turn signal lights will not self-cancel
while you are stopped at an intersec-
tion.
1. Dimmer switch “ / ”
2. Turn signal switch “ / ”
3. Horn switch “”
1. Engine stop switch “ / ”
2. Start switch “”
U5PX13E0.book Page 5 Monday, May 10, 2004 9:26 AM