Owner's Manual

Panel Operation — UTILITY screen
33
PX10/PX8/PX5/PX3 Reference Manual
To set a PIN code
1. Open the PIN code input screen.
In MENU screen–UTILITY screen–PANEL LOCK screen, select “PIN CODE”
(page 32).
The cursor is on the first digit of the PIN code.
2. Rotate the main knob to select a digit, and then press the main
knob to enter it.
After the digit is entered, the cursor moves to the next digit.
3. Enter the subsequent digits in the same way.
4. After inputting four digits, press the [OK] key.
The PIN code is entered.
HOME SCREEN (HOME screen)
(Advanced mode only)
Sets contents of the HOME screen.
q dB VALUE
Select the value type in the VOL/BAL/GAIN indication in HOME screen (page 15).
•VOL: Input volume
GAIN: Total level (gain from the input jack to the speaker output terminal)
w METER
Selects the level indicated in the level meter, input signal or output signal.
INPUT: Input signal level
•OUTPUT: Output signal level
LOAD SP PRESET (load speaker preset)
Loads a speaker preset downloaded and stored in a USB flash drive to the PX amplifier.
q LOAD FROM USB
Loads a speaker preset from a USB flash drive.
NOTE
While the PIN code is being input, you can correct it by pressing the [ ] (back) key and
selecting the desired digit with the main knob.
NOTE
If the PIN code is changed to “0000,” the PIN code is not set. In this state, PIN code input is
not needed to set or release the panel lock.
NOTE
Speaker presets can be downloaded from the Yamaha Pro Audio global website.
q
w
q