Operation Manual

12
All accessories (except SR-PC
and SR-PVC) are pre-set to
“entry” mode.
When the system is rst armed, users will have 30
seconds to exit the building. If the system is already
armed, triggering any sensors will cause an entry
countdown to begin.
SR-PC/SR-PVC’s default setting is “Burglar only”, i.e.
immediate triggering during full arm and sleep during
Home Arm. This is done to conserve battery life.
Supervision is set to disabled
as default (recommended).
Note: Do not enable this unless advised
by a professional installer.
When the alarm is triggered, the
system will send an email, push
notication and SMS to alert the
owner.
It is not possible to arm the
system with “open” Door/Window
Contact (i.e. windows open).
Jamming and interference
detection disabled as default.
External Siren Comfort LED
is set to disabled as default
(recommended).
About your Alarm System (Default Settings)
6
To change the behavior mode on accessories,
please see APP – “Controller” -> “Device List” ->
choose each device to change .
• Burglar - Instant Alarm upon activation in both
Away and Home Mode
• Home Omit - No activation under Home Mode,
but will in Away Mode.
• Home Access - Give 30 sec. delay when
activated under Home Mode, Instant Alarm
upon activation in Away Mode
• Entry Zone - Upon activation gives a 30 sec.
delay in both Away and Home Mode.
To change the exit and entry timer, please enable
via App -> “Controller” -> “Panel Setting”
Enable or disable supervision detection on the Smart
Hub. PIR, Door/Window Contact, or Siren can be
monitored for outage and malfunctions using this
feature. With the exception of the PIR Image Camera,
PIR Video Camera and Smoke Detector (which are
always on), the other three accessories need to have
supervision enabled on board to facilitate this feature.
Supervision can be enabled via “Controller” ->
“Panel Setting”.
The network trac condition will determine
how quickly the user is alerted. There may be a
noticeable delay should the third party email/SMS
gateway become congested.
You will be prompted on the App when trying to
arm with your door/window open.
If jamming and interference is of concern, please
enable via “Controller” -> “Panel Setting”
The Comfort LED function starts a ashing
light on your external Siren when enabled. This
function will signicantly reduce the battery life of
your Siren.
You can enable the Comfort LED via “Devices” ->
“Siren Properties” (arrow on the right).
7