Operation Manual
VX-8R OPERATING MANUAL44
12. When you wish to add a beep tone into the beep melody
strings, move the cursor to the place where you wish to en-
ter the beep tone using the / key, then press the
key repeatedly until the “
SELECTSELECT
SELECTSELECT
SELECT” notation in the “Op-
eration Mode” slot turns into “
INSERTINSERT
INSERTINSERT
INSERT”. Now, press and hold in the key for one
second to add the new beep tone (Tone: “C2”, Tone Length: “500mS”).
13. Press and hold the key for one second to delete all data after the current position
that may have previously been stored in the User Beep Melody.
14. When you have programmed User Beep Melody, press the PTT switch briefly to save
the new setting and exit to normal operation.
You may check your work by monitoring the programmed User Beep Melody.
To do this, repeat steps 1 - 4 above, then press the key.
SPLIT TONE OPERATION
The VX-8R can be operated in a Split Tone configuration via the Set mode.
1. Press and hold the key for one second to enter the Set Mode.
2. Rotate the DIAL knob to select Set Mode Item
94: SQL94: SQL
94: SQL94: SQL
94: SQL
SPLITSPLIT
SPLITSPLIT
SPLIT.
3. Press the key briefly to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select “
ONON
ONON
ON” (to enable the Split
Tone feature).
5. Press the PTT switch briefly to save the new setting and
exit to normal operation.
When the Split Tone feature is activated, you can see the following additional parameters
after the “
MESSAGEMESSAGE
MESSAGEMESSAGE
MESSAGE” parameter while selecting the Set Mode Item
95: SQL TYPE95: SQL TYPE
95: SQL TYPE95: SQL TYPE
95: SQL TYPE:
D CDD CD
D CDD CD
D CD: DCS Encode only (“
DCDC
DCDC
DC” icon will appear while operating)
TONE-DCSTONE-DCS
TONE-DCSTONE-DCS
TONE-DCS: Encodes a CTCSS Tone and Decodes a DCS code
(the “
T-DT-D
T-DT-D
T-D” icon will appear during operation)
D CD-TONE SQLD CD-TONE SQL
D CD-TONE SQLD CD-TONE SQL
D CD-TONE SQL: Encodes a DCS code and Decodes a CTCSS Tone
(the “
D-TD-T
D-TD-T
D-T” icon will appear during operation)
Select the desired operating mode from the selections shown above.
CTCSS/DCS/EPCS OPERATION
CTCSS/DCS/EPCS BELL OPERATION