Operation Manual

81
Scanning
SignalSearch
4 Touch [2MEMSCANTYPE] and select “SELECT
MEM”
The setting will switch between“ALL MEM” and
“SELECT MEM” each time it is touched.
5 Press for one second or longer
The display will return to the previous screen.
$#%-
$#%-
.#4)'Ჹ
Ჺ /'/5%#06;2'
#.2*#6#)5+<'
#../'/
6 Press
The function menu will be displayed.
7 Touch [SCAN]
The scan only those memory channels that have
been set to “SELECT” will be started.
Tips  •Thescancanalsobestartedbypressingthe[UP] or
[DWN] button on the microphone for one second or
longer.
Ჹ
᲼
Ჽ
Ჾ
Ჸ
Ჸ
ᲹᲺ᳀
;1-1*#
/
#
᲼
᲻᲻
᳀
ᲾᲸ
ᲽᲸ
Ჸ
61-;
1

Ჺ᲻
/76'
5%12'
/8 53.
5-+25'.
5'.'%6
&9
6Z294
*+
5%#0
4'8
(9&$#%-
 •Thescanwillbeperformedinincreasingorderofthememorychannelnumber.
 •Whenasignalisreceived,thescanningstopsforthreesecondsandthenthescanningstarts
again.
 •Tostopthescanning,eithertouch[SCAN] or press the microphone [PTT] button (the radio
will not transmit in this case).
Settingthememoriestobeskipped
Memory channels which you do not wish to receive can be skipped during scanning.
The channels to be skipped can be set using the following two methods:
(1) Designate channels using the memory list screen
(2) Sets channels individually using the function menu screen
(1)Designatingchannelstobeskippedusingthememorylistscreen
1 Touch [V/M] for two to three seconds (until the beep
sounds)
The memory list screen will be displayed.
Ჹ
᲼
Ჽ
Ჾ
Ჸ
Ჸ
ᲹᲺ᳀
;1-1*#
/
#
᲼
᲻᲻
᳀
ᲾᲸ
ᲽᲸ
Ჸ
61-;
1

Ჺ᲻
/76'
5%12'
/8 53.
2 Turn to select the memory to be skipped
Tip The memory can also be selected by touching it directly.