Operation Manual

160
Functions to Use as Necessary
Clone Operation
Data and various settings saved in your transceiver can be copied to any other FT2DR/
DE transceiver.
DATA
terminal
DATA
terminal
1 Turn off the power of both FT2DR/DE transceivers, then connect an optional clone
cable (CT-168) to the DATA terminal of each transceiver.
2 While pressing and holding the keys on both FT2DR/DE transceivers, press
.
The two transceivers are turned on and placed in the clone mode.
3 Touch [RECEIVE] on the receiving side transceiver and [SEND] on the transmitting
side.
Data copy starts.
When data copy starts, the display on the receiving transceiver changes from “--WAIT-
-” to “--RX--”. On the transmission side transceiver, when data transmission begins,
the transmission data amount indicator appears on the LCD. On the receiving side
transceiver, when data reception starts, the indicator appears on the LCD as well.
Tips When copying is completed, the receiving side transceiver returns to the normal mode. On the
transmission side transceiver, the indication on the LCD returns from “--TX--” to “CLONE”.
4 Turn off the power of both transceivers, then disconnect the clone cable.
Cautions
y When the “ERROR” appears on the LCD during data transfer, copying cannot be completed. Check
the clone cable connection, and redo the operation from the beginning.
y Time data cannot be copied.