Operation Manual

150
Customize Menu Settings for Individual Use (Set Mode)
Set Mode: CONFIG Menu Operations
When the valid password is entered, the frequency display screen appears.
Remark If an invalid password is entered, the transceiver is turned off automatically.
Caution
If you have forgotten the registered password, carrying out all resetting allows you to turn on the
transceiver without entering the password.
It should be noted that performing all resetting resets (initializes) all information such as the information
registered to memory channels and various setting values.
It is recommended that the password be written down on paper.
Setting the PTT Delay Time PTT DELAY Function
Set a timed delay before actual transmission begins after is pressed.
1 Rotate the DIAL, then touch [13 PTT DELAY].
2 Rotate the DIAL to select the desired setting.
OFF/20ms/50ms/100ms/200ms
Selecting OFF disables the PTT delay time function.
Remark The default setting: OFF
Setting the ARS Function
RPT ARS Function
Enable or disable the automatic Repeater Shift operation ARS (Repeater operation is
initiated by tuning to the repeater frequency).
1 Rotate the DIAL, then touch [14 RPT ARS].
2 Rotate the DIAL to select the desired setting.
ON Enables the ARS function.
OFF Disables the ARS function.
Remark The default setting: ON
Setting the Repeater Shift Direction
RPT SHIFT Function
Set the TX frequency shift direction for repeater use.
1 Rotate the DIAL, then touch [15 RPT SHIFT].
2 Rotate the DIAL to select the desired setting.
SIMPLEX No TX frequency offset.
-RPT Shifts TX to a lower frequency.
+RPT Shifts TX to a higher frequency.
Remark The default setting differs depending frequency