Operation Manual

114
Communicating with a Specific Remote Station
Using the Tone Squelch Function
Tips
• The vibrator can function for all frequency bands belonging to A-band (Main) and B-band (Sub).
• If you select [BUSY] in step 5, when the transceiver receives a signal, BUSY LED and the vibration
function turn on simultaneously regardless of the communication mode or squelch type.
• The vibrator functions when the vibrator setting is other than OFF. Press
to perform transmission,
and release
to deactivate the vibrator for 5 seconds.
Selecting the Vibrator Operation Mode
1 Press and hold the key for over one second.
The transceiver enters Set mode.
2 Touch [CONFIG].
3 Touch [22 VIBRATOR], then press the key.
4 Rotate the DIAL to select [SELECT], then press the key.
5 Rotate the DIAL to select the desired vibrator operation.
Remark The default setting: PATTERN1
PATTERN1 The vibrator functions continuously.
PATTERN2 The vibrator functions at long intervals.
PATTERN3 The vibrator functions at short intervals.
6 Press .
The selected vibrator operation is set and the transceiver exits from Set mode.
Notification of a Call from a Remote Station by the
Bell Function
Set the Bell sound to alert you of a call from a remote station containing a corresponding
tone or DCS code.
on the LCD blinks at the same time.
1 Press and hold the key for over one second.
The transceiver enters Set mode.
2 Touch [SIGNALING].
3 Touch [1 BELL].