Operation Manual

Page 138 FT DX 9000MP OPERATION MANUAL
MENU MODE
045. CW AUTO MODE
Function: Enables/disables CW keying while operat-
ing on SSB.
Available Values: OFF/50MHz/ON
Default Setting: OFF
OFF: Disables CW keying while operating on
SSB.
50MHz: Enables CW keying only while operating
SSB on 50 MHz (but not HF).
ON: Enables CW keying while operating on SSB
(all TX bands).
Note: This feature allows you to move someone from
SSB to CW without having to change modes on the
front panel.
046. CW BFO
Function: Sets the CW carrier oscillator injection side
for the CW mode.
Available Values: USB/LSB/AUTO
Default Setting: USB
USB: Injects the CW carrier oscillator on the USB
side.
LSB: Injects the CW carrier oscillator on the LSB
side.
AUTO: Injects the CW carrier oscillator on the LSB
side while operating on the 7 MHz band and
below, and the USB side while operating on
the 10 MHz band and up.
047. CW BK-IN
Function: Sets the CW “break-in” mode.
Available Values: SEMI/FULL
Default Setting: SEMI
SEMI: The transceiver will operate in the semi break-
in mode. The delay (receiver recovery) time is
set by the front panel’s CW DELAY knob.
FULL: The transceiver will operate in the full break-in
(QSK) mode.
048. CW WAVE SHAPE
Function: Selects the CW carrier wave-form shape
(rise/fall times).
Available Values: 1/2/4/6 msec
Default Setting: 4 msec
049. CW WEIGHT
Function: Sets the Dot:Dash ratio for the built-in elec-
tronic keyer.
Available Values: (1:) 2.5 ~ 4.5
Default Setting: 3.0
050. CW FREQ DISPLAY
Function: Frequency Display Format for the CW
mode.
Available Values: DIRECT FREQ/PITCH OFFSET
Default Setting: PITCH OFFSET
DIRECT FREQ: Displays the receiver carrier fre-
quency, without any offset added.
When changing modes between
SSB and CW, the frequency display
remains constant.
PITCH OFFSET: This frequency display reflects the
added BFO offset.
051. PC KEYING
Function: Enables/disables CW keying from the “DATA
IN” terminal on the rear panel’s PACKET jack while
operating on the CW mode.
Available Values: DISABLE/ENABLE
Default Setting: DISABLE
052. QSK
Function: Selects the time delay between when the
PTT is keyed and the carrier is transmitted during QSK
operation when using the internal keyer.
Available Values: 15/20/25/30 msec
Default Setting: 15 msec
MODE-CW GROUP