Operation Manual
Page 118 FT DX 9000MP OPERATION MANUAL
MEMORY OPERATION
1. Press the MCH/GRP key (# ) momentarily.
The imbedded LED will glow Red, indicating that
you are now ready to view memory channel con-
tents.
Advice
If the Red LED imbedded in the MCH/GRP
switch does not light up, check to be sure that the
orange lamp to the right of the
CLAR/VFO-B
knob (# ) is not illuminated. It it is, press the
A/B switch (# ) to make it go out, then press
the
MCH/GRP key again.
2. Press the AM key (# ).
The data stored in the currently-selected memory
channel will be displayed in the Sub (VFO-B) band
frequency field. However, since you are only check-
ing the contents of the memory channel, your radio
will not have moved to the memory channel's fre-
quency.
3. Rotate the CLAR/VFO-B knob to select other
memory channels. To exit from the Memory Check
mode, press the AM key once more.
ERASING MEMORY CHANNEL DATA
1. Press the MCH/GRP key (# ) momentarily. The
imbedded LED will glow Red, indicating that you are
now ready to view memory channel contents.
Advice
If the Red LED imbedded in the MCH/GRP switch
does not light up, check to be sure that the orange lamp
to the right of the CLAR/VFO-B knob (# ) is not
illuminated. It it is, press the A/B switch (# ) to
make it go out, then press the MCH/GRP key again.
2. Press the AM key (# ).
The data stored in the currently-selected memory chan-
nel will be displayed in the Sub (VFO-B) band fre-
quency field.
3. Rotate the CLAR/VFO-B knob to select the memory
channel that you would like to erase.
4. Press the LOCK switch (# ) to erase the contents
of the selected memory channel.
Advice
After erasure, only the memory channel number will
remain; the frequency data will disappear from the
display.
If you make a mistake and wish to restore the memory’s
contents, just repeat steps (1) through (3) above.
Advice
While the Memory Check function is engaged, the
memory channel number will blink.
While operating in the VFO mode, using Memory
Check, you may store the current contents of the
VFO into the selected memory by pressing and hold-
ing in the AM key for two seconds (until the
double beep). Conversely, if you wish to write the
contents of the current memory into the Main (VFO-
A) register, press and hold in the MA key (# )
for two seconds.
Checking a Memory Channel’s Status
Before programming a channel into memory, you can check the current contents of that channel without the danger of
over-writing the data accidentally.
MEMORY CHANNEL RECALL
CLAR/VFO-B Knob
MCH-GRP KeyAM Key
MA Key
CLAR/VFO-B Knob
MCH-GRP KeyAM Key
LOCK Key