User's Manual

FCC ID: K6620275X40
IC ID: 511B-20275X40
FTM-10R Operating Manual
SF5 RESET: Clears all memories and other settings to factory defaults.
SF6 RBT PAIR: Set up the Bluetooth device which is connected to the transceiver.
This is not reset operation.
SF7 FBT PAIR: Set up the Bluetooth device which is connected to the front panel of
the transceiver. This is not reset operation.
4. Press the [PTT] key to appear the notation (YES?), press the [PTT] key again to
complete the reset procedure, once you have made your selection in step 3. Turn off
the transceiver (press and hold the [PWR] key for two seconds) to cancel the reset
procedure.
Set (Menu) Mode
The FTM-10R Set Mode, already described in parts of many previous chapters, is easy
to activate and set. It may be used for configuration of a wide variety of transceiver
parameters, some of which have not been detailed previously. Use the following
procedure to activate the Set Mode:
1. Press and hold the [SELECT] key for two seconds to enter the Set mode.
2. Rotate the DIAL knob to select the Set Mode Item to be adjusted.
3. Press the [X] key momentarily to enable adjustment of the Set Mode Item.
4. Rotate the DIAL knob to adjust or select the parameter to be changed on the Set
Mode Item selected in above step.
5. After completing your selection and adjustment, press the [SELECT] key
momentarily to save the new setting and exit to normal operation.
Set Mode Summary
Set Mode Item [F1 AF DIFF]
Function: Enables/Disables the Automatic Audio Volume Controller.
Available Values: OFF/ON MIN/ON MID/ON MAX
Default: OFF
ON MIN: Activates the Automatic Audio Volume Controller with the low effect level.
ON MID: Activates the Automatic Audio Volume Controller with the medium effect
level.
ON MAX: Activates the Automatic Audio Volume Controller with the high effect level.
OFF: Disable the Automatic Audio Volume Controller.
Set Mode Item [F2 AF PITCH]
Vertex Standard Co., Ltd.
45