Manualshelf

User's Manual

ManualsBrandsYaesu Musen ManualsElectronicsSCANNING RECEIVER
31323334353637383940
Table Of Contents
FCC ID: K6620275X40
IC ID: 511B-20275X40
FTM-10R Operating Manual
6. Rotate the DIAL knob to select the first character of the personal ID you wish to
store, then press the [BANDS] key momentarily to save the first character of the
personal ID and move on to the next place.
7. Repeat previous step to complete the personal ID. If you a mistake, press the
[BANDT] key to move back to the incorrect character, then re-enter the correct
character.
8. When the personal ID entry is complete, press and hold in the [X] key for one
second.
9. If you wish to store another personal ID, repeat steps 4 through 8 above.
10. Press the [SELECT] key momentarily to save the new setting and exit to normal
operation.
Set your Personal ID
You choose your personal ID from the member list.
1. Press and hold the [SELECT] key for one second to activate the Menu (SET) mode.
2. Rotate the DIAL knob to select Menu Item “F19 MY-ID.”
3. Press the [X] key to enable selection of this Menu Item.
4. Rotate the DIAL knob to select the member box (1 ~ 20) which your ID is stored.
5. Press and hold the [X] key for one second to clear any previously personal ID.
6. Press the [SELECT] key momentarily to save the new setting and exit to normal
operation.
CLUB Channel
In the factory default, 430.000 MHz frequency is stored in the CLUB channel. If you
change the CLUB channel, perform the following procedures:
1. Press and hold the [SELECT] key for one second to activate the Menu (SET) mode.
2. Rotate the DIAL knob to select Menu Item “F12 CLUB CH.”
3. Press the [X] key. The current CLUB channel frequency appears in the display.
4. Press and hold the [X] key for one second to enable changing the CLUB channel
frequency.
5. Press the [BANDS]/[BANDT] key to change the amateur band, if needed, then
rotate the DIAL knob to select the new CLUB channel frequency.
6. Press and hold the [X] key for one second to save the new CLUB channel frequency.
7. Press the [SELECT] key momentarily to exit to normal operation.
Sending a Messages
Vertex Standard Co., Ltd.
35