ALL TERRAIN POWER CART ITEM: 61034 OWNER’S MANUAL AND SAFETY INSTRUCTIONS SAVE THIS MANUAL: KEEP THIS MANUAL FOR SAFETY WARNINGS, PRECAUTIONS, ASSEMBLY, OPERATING, INSPECTION, MAINTENANCE AND CLEANING PROCEDURES. WRITE THE PRODUCT’S SERIAL NUMBER ON THE BACK OF THE MANUAL NEAR THE ASSEMBLY DIAGRAM (OR MONTH AND YEAR OF PURCHASE IF PRODUCT HAS NO NUMBER).
IMPORTANT SAFETY INFORMATION SAFETY Read and thoroughly understand all instructions and safety information before assembling or operating this All Terrain Power Cart. Failure to do so may cause serious injury or death. DO NOT allow anyone to operate this equipment who has not read this manual. As with all power equipment, an All Terrain Power Cart can be dangerous if assembled or used improperly. DO NOT operate this equipment if you have doubts or questions concerning safe operation.
IMPORTANT SAFETY INFORMATION NEVER run the engine in an enclosed area or without proper ventilation as the exhaust from the engine contains carbon monoxide, which is an odorless, tasteless, and deadly poisonous gas. Fill the gasoline tank outdoors with the engine off and allow the engine to cool completely. The muffler and engine become very hot with use and can cause a severe burn; DO NOT touch. Allow the engine to cool before refuelling, doing maintenance, or making adjustments.
PRODUCT INFORMATION FILLING WITH GASOLINE AND OIL: ADD OIL BEFORE STARTING THE ENGINE The Power Cart is shipped without fluids installed. Keep the caps on the fuel and oil fills until you are ready to pour either gasoline or oil into the correct fill. Oil capacity: 3.6L of SAE 10W30 engine oil. 1. Place the machine on a level surface and initially add 1/2 of the SAE 10W30 high detergent oil into the oil fill and wait one minute for the oil to settle. 2.
OPERATION STARTING THE ENGINE: FOLLOW THE PROCEDURE BELOW FOR COLD STARTS: 1. Turn choke lever on the engine to the CLOSED position. 2. Set the throttle lever on the handlebar at halfway position 3. Turn the engine switch on. 4. Pull the starting rope slowly several times to allow the gasoline to flow into the engine’s carburetor. Then hold the start handle firmly and pull rope out a short distance until you feel some resistance. Then pull the rope smoothly and briskly, and allow rope to return gently.
MAINTENANCE TURN OFF ENGINE AND DETACH SPARK PLUG WIRE. Allow engine to cool before performing maintenance. Check the Power Cart for loose screws, misalignment or binding of moving parts, cracked or broken parts, and any condition that may affect safe operation. Remove debris and other materials that may have accumulated in and around the tracks. Clean after each use. Use a premium lightweight machine oil to lubricate moving parts. DO NOT use a “pressure washer” to clean the Power Cart.
MAINTENANCE The belt is not separated completely, tensioning position please V belt adjustment. Removed bolt belt wheel cover, belt tensioner in the parking position does not contact the V belt, do not rotate in [walk] and position. Then tighten the bolts, tighten the nuts. Checking and Adjusting the Brakes: 1. Take off the plastic cover 2. Put the walking clutch rod to Stop the machine position 3. Make sure the spring length A is between 185-190mm, adjust if there is any inappropriate. 4.
TROUBLESHOOTING 7
SPECIFICATIONS 8
IMPORTANT INFORMATION PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.