Full Product Manual

READ AND S A
V
E THESE INSTRUCTIONS
W
GR C SB SI SP
HECO
V
IMPORTANT SAFETY INSTRUCTIONS
2
1
INSTALLATION AND OWNER’S MANUAL
XLERATOR
®
AND XLERATOReco
®
HAND
DRYER MODELS
MODELS: XL -
BW
WITH OR WITHOUT SUFFIX:
1. Unpack all items from the shipping box.
2.
Inspect items against the following list.
1. Hand Dryer
2. Tamper Proof Wrench.
3. Installation and Owner’s Manual.
3. Report any missing or damaged items.
4. Locate the Dryer Model Number and Serial Number on
the Dryer nameplate and record the data below.
5. Read and save these instructions.
Dryer Model
Serial Number
Date Of Purchase
110–120V 11.3 – 12.2A
208–277V 5.6 – 6.2A
110–120V 4.3 – 4.5A XLERATOReco
208–277V 2 – 2.2A XLERATOReco
GENERAL SAFETY INSTRUCTIONS
• Troubleshooting and internal maintenance must be performed
by qualified service personnel.
• Do not use any power wash equipment for cleaning on or
near this unit.
• Do not use the XLERATOR dryer for drying hair.
• Do not obstruct air inlets or outlets.
PRE INSTALLATION WIRING SAFETY INSTRUCTIONS
• Check that the electrical supply corresponds to that shown
on the rating sticker of unit. Do not connect the dryer to any
electrical supply other than that stated on the rating sticker of
the unit. Permanent damage or improper, unsafe operation of
the unit may result.
• Make sure electricity is switched off at the main panel before
installing, maintaining or cleaning this hand dryer.
• The Dryer must be installed in accordance with current
local wiring and building regulations.
• Do not wire this hand dryer into the lighting circuit. It must be
protected by an independent circuit.
• The Dryer is intended to be permanently connected to the
power supply, and must be properly grounded.
EXCEL DR YER ,
357 CHESTNUT
INC 1.800.255.9235 EXCELDR YER . COM
S T R E E T, E A S T L O N G M E A D O W , MA 0 1 02 8
A D M I N @ E X C E L D R Y E R . C O M
07/2017 1
MODEL INFORMATION
RECEIVING SHIPMENT
3
Warning: For proper electrical connections, check
your local building codes.
Your unit must be installed by a qualified,
li censed electrician.
Warning: To reduce the risk of fire, electric shock
or injury to persons, observe the following:
A. Use this unit only in the manner intended by the
manufacturer.
B. Before servicing or cleaning unit, switch power off
at service panel and lock the service disconnect-
ing means to prevent power from being switched
on accidentally. When the service disconnecting
means cannot be locked, securely fasten a promi-
nent warning device, such as a tag, to the service
panel.