80 Series Printer User Manual
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Catalogue I. Product Introduction .........................................................................................................3 1.1 Warnings: ......................................................................................................................3 1.2 Notice ............................................................................................................................3 II. Summary ........................................................................................
I. Product Introduction 80 series printer is a POS direct thermal receipt printer with easy operation and high cost effective, which is widely used in supermarket, hospital, restaurant, bank, oil station, turnpike etc. Safety Notice Please read carefully and strict compliance with use of following instructions before operating the printer. 1.1 Warnings: Warning: Do not touch the cutter of printer.
(9) In order to ensure the printing quality and extend the life of printer, please use the recommendatory thermal paper or the one which has the same quality. (10) Please make sure the power of printer is off when plugging the connecting line. (11) Please keep the user manual for reference when needed. II.
USB Serial Ethernet Cash Drawer Power Supply Cash Drawer Control：6 lines RJ-11 socket，output: DC24V/1A ● Character ASCII code character set：12×24 dots，1.25（W）×3.00（H）mm Chinese character：24×24 dots，3.00（W）×3.00（H）mm International Code page: 10 types of international language--- PC437、 Katakana、PC850、PC860、PC863、PC865、WPC1252、 PC866、PC852、 PC858 and so on. Printing Barcode：Supports 9 types of barcode printing, UPC-A、UPC-E、 EAN(JAN)13、EAN(JAN)8、CODE39、CODABAR、ITF、CODE93、 CODE128 and so on.
(5) Please pay attention to the temperature, humidity and illumination of the storage for thermal paper. The paper would fade if the storage temperature is over 70 centigrade. 6 ● （MCBFM）Mechanical reliability: 6×10 lines ● Emulation: ESC/POS Print Font：Support ANK. The font could be magnified, bolded or underlined and the user also could adjust the character spacing before printing.
Paper roll CD Communication cable 4.2 Printer Connection (1) To ensure the printer and PC is powered off and then insert the matched data connection lines to the interfaces (USB/Parallel/Serial) of the printer, the other ends are to the PC. (2) If the user fit out the electric opened cash drawer for the printer that could insert the RJ-11 connection line of it to the corresponding interface of the printer. (PS: The specification of cash drawer should be accorded with the driver requirement of printer).
(4) Do not pull the power soft wire when unplugging. If the user does it by force, it may result in the breakdown of the printer and power adapter. 4.3 Load the Paper Roll Model: 80 printers, with easy paper loading, uses 80mm width thermal paper. The loading instruction is listed as below: (1) Open the top cover of printer. Open Button (2) Load the thermal paper into printer as the following picture. (3) Pull a part of paper out and then close the top cover.
(4) Use the cutter of printer to tear off the extra paper V. Power Switch, Keystroke and Indicator Light 5.1 Power Switch Switch is for turning on/off the power supply of printer which is located on the left. When pressing “-”, the printer turns on and when pressing “O”, it turns off. Notice: Do not turn on the switch unless the user connects the power supply. 5.
Light appears under following condition: Paperless, paper jam, print head overheat, print head error or other situations. PAPER Key（Red） ： Light appears when paperless. 5.3 Setting Printer Mode 80 printer is initially setup with default value. However, the default printer mode can be reconfigured to satisfy customer’s needs through the DIP switch, which is located at the bottom of the printer.
power, then press the feed key and switch on the power supply while the key is still under pressing. At the same time, the printer begins to self-checking. Please loosen the key within five seconds and the printer would print the self-testing list after it. VI. Cash Drawer Interface Cash drawer interface adopt RJ-11 standard, 6 lines socket and it outputs DC 24V/1A. Insert the RJ-11 socket to the corresponding interface which could through the printer to open the cash drawer.
(3) Use the cotton cloth and dip it in the absolute ethyl alcohol to clean the surface of print head. (4) When the absolute ethyl alcohol is completely volatilized, please close the top cover and restart the printer. 7.2 Sensor Maintenance When the printer has following circumstance, the user should clean the paperless sensor: (1) During the printing, the printer occasionally stops print and the paperless alarm is beeping. (2) No paperless alarm.
(1) The power supply of printer should be turned off when the routine maintenance. (2) Do not use hand or metal to touch the surface of print head and not use tweezers to scratch the superficies of print head, print roll or sensor. (3) Do not use oil or acetone to do the maintenance. (4) When the absolute ethyl alcohol is completed volatilized, then turn on the power to print. VIII.
If the self-checking can work, please check the following contents: (1) Check the interfaces of printer and computer and also check whether the connected line between them is to their specification requirement. (2) The setting of data transmission between printer and computer may be different. You know the printer’s interface setting through the self-testing page. Please contact the agent or technical support if the printer cannot print. X.
