XDC 6000 Watt and 12000 Watt Series DigitalProgrammable DC Power Supply Operating Manual

SCPI Command Summary
TM-XDOP-01XN C–19
Table C-9 System Commands
Function SCPI Command Description Query
Query System Error
[:]SYSTem[<channel>]:ERRor[:NEXT]?
Returns the next error in the
instrument’s error queue
N/A
Recall Default
Factory Preset
[:]SYSTem[<channel>]:RECall:DEFault
Restore the factory preset values N/A
Select Remote
Control Source
[:]SYSTem[<channel>]:REMote:SOURce
{RS232|GPIB|AVOLtage|ACURrent|AVCurrent|MCHann
el}
Select the remote control source Yes
Set RS-232 Baud
Rate
[:]SYSTem[<channel>]:COMMunicate:SERial[:RECei
ve]:BAUD {1200|2400|4800|9600|…}
Configure the RS-232 baud rate Yes
Set RS-232 Flow
Control
[:]SYSTem[<channel>]:COMMunicate:SERial[:RECei
ve]:PACE {HARDware|XON|NONE}
Select type of flow control for
RS-232
Yes
Set Multichannel
Address
(6000 W only)
[:]SYSTem[<channel>]:COMMunicate:MCHannel:ADDR
ess <channel>
Select the multichannel unit
address
Yes
Set GPIB Address
[:]SYSTem[<channel>]:COMMunicate:GPIB[:SELF]:A
DDRess <GPIB_address>
Configure GPIB address Yes
Set GPIB Power On
Service Request
[:]SYSTem[<channel>]:COMMunicate:GPIB[:SELF]:P
ONSrq {ON|OFF|0|1}
Configure GPIB PON SRQ Yes
Select Range for
Analog
Programming
Interface
[:]SYSTem[<channel>]:COMMunicate:APRogram:LEVe
l {5|10}
Select analog interface voltage
levels
Yes
Set Remote Control
Operation (Serial
Interface)
[:]SYSTem[<channel>]:REMote:STATe
{LOCal|REMote|RWLock}
RS-232 Only. Change remote
control mode
Yes
Query SCPI Version
[:]SYSTem[<channel>]:VERSion?
Returns the SCPI version to
which the instrument complies.
Format is YYYY.V
N/A
TM-XDOP-01XN.book Page 19 Monday, July 17, 2006 11:19 AM