Instruction manual

13
Technical Support: [e-mail] US: [phone] EU: [phone]
ADVANCED OPERATION
IR Matrix
Select the
button to check current settings attached to the IR port.
Com Connect State - Shows if the matrix is
connected or disconnected to the Com Port and
communication is enabled. Selection between ports is
available by pressing the Com Port Select button.
When connected, the only option will be to Disconnect
and vice versa. Press to connect/disconnect the matrix
from the software control.
• Connected for matrix communication enabled
• Disconnected for matrix communication disabled
Com Select
Connect/Disconnect
Click the Com Select dropdown to see all Com ports
available. Select your chosen Com port number and press
the CONNECT button. You will notice the button change
toshow ‘disconnect’ and CONNECT STATE change
to green for ‘connected’. Pressing the button again will
disconnect the Com port and the CONNECT state will
show red.
Input/Output Switch - Switches connected inputs
per output.
5
6
7
8
7
8
9
Operation as with remote control handset – select the
chosen input to be displayed on each output by either
clicking the left/right arrow buttons to scroll through inputs
numerically, or pressing the input number 1-4.
iii. LAN Control with SmartSet Gui
The matrix can also be controlled via LAN over a network/
web browser using the supplied WyreStorm software
or LAN protocols from third party companies, such as
Control 4.
Attention Use a ‘straight through’ ethernet cable
for switch/router connection and a ‘cross-over’
cable for connection to a PC. Using the incorrect
cable will not damage your equipment, but it may
result in poor/no connection. Make sure that
your LAN cable is correctly terminated and firmly
connected to ports before running the software
Unzip the file WS IP Device Scanner ( NEW LAN
BOARD) and double click on the SmartSetGui application
Initially the document is in Chinese. To change this,
click on the characters on the top of the tool bar with a (L)
next to it, and select English from the menu options.
You may have to exit and re-enter the application for the
change to take effect.
If you do not initially see your matrix being
connected, click on the SEARCH button
a. If it is recognized, it may show up as the default Matrix
8:8 setting rather than MX-0404-PP-KIT
1
2
3