Installation Guide

INSTALL OVERFLOW
22. Place hand and use ngers to lift up
overow from bottom edge as pictured.
(gure 10)
23. Tilt up then pull out the overow from holes
on it’s base. (gure 11)
24. To replace new overow, simply match position
of screws located on rear of overow and push
until it is locked into holes. (gure 12)
If you purchased a Brushed Nickel pop up
overow, or any other trim kit nish, please
follow these replacement instructions.
It is highly recommended that you do not use any
sharp objects to remove the overow, for it will
cause surface damage to the tub as well as the
overow itself.
(figure 10)
(figure 11)
(figure 12)