User's Manual

C-5000 COMMUNICATION MANAGEMENT CONTROLLER
INSTALLATION MANUAL
Publication No. 150-041118 Page 4-103
Rev C Section 4 –Electrical Installation
May 2006
All the above boils down to the following: To use RT-5000 #1, put the "Take_Control"
switch in the position so the operators control head shows the status of RT-5000 #1. To
transmit, put the audio panel on FM1. Do the same for transceiver #2 except use
Take_Control switch for RT-5000 #2 and then select FM2 on the audio panel.
If an operator wants to control both RT-5000's from one control head, put the
Take_Control switches in the position that shows the status of both radios on the control
head. Use the FM1 position on the audio panel when talking on RT-5000 #1. Use the
FM2 position on the audio panel when talking on RT-5000 #2.
Other Key Points / Operational Considerations:
a) At no time can both control heads EVER tune the same transceiver. Only one
control can have control of a transceiver at any time. There is no
communication between the two control heads so the head without control will
not show anything other than "NO CONTROL".
b) Mic/Headset audio for transceiver #1 is connected to the Primary mic/headset
port of P500. To transmit on RT-5000 #1 the user must put the audio panel to
the FM1 position regardless of which control head has control of transceiver
#1.
c) Mic/headset audio for transceiver #2 is connected to the Secondary
mic/headset port of P500. To transmit on RT-5000 #2 the user must put the
audio panel to the FM2 position regardless of which control head has control of
transceiver #2.