Installation Instructions

Secure glass (Q) onto the socket (P) by screwing socket ring (R)

tightly. Install light bulb (not included) in accordance with the

fixture’s specifications. Do not exceed the maximum

recommended wattage.

Carefully remove all contents from the carton. See the

important notes above. Shut off the power at the circuit

breaker and completely remove the old fixture from the

ceiling, including the old mounting bracket. Remove the

mounting bracket assembly from the bag. Mounting

bracket (B) contains several pairs of threaded holes. Find

the pair of holes that matches the spacing of the holes on

the junction box and the fixture’s canopy. Two mounting

screws (A) should be attached to mounting bracket (B).

You may need to tighten nuts (C) to hold these screws in

place. Pull the house wires through the center of mounting

bracket (B). Place mounting bracket (B) over the junction

box so that mounting screws (A) are vertical and aligned

with the hole locations on the fixture’s canopy (F). Secure

mounting bracket (B) to the junction box by tightening the

screws.

bracket

There are two 18 inch rods (K), two 12 inch rods (L), and

two 6 inch rods (M) included for each fixture. Determine

the correct number of rods needed for proper hanging height.

To lengthen the fixture, add additional rods. If additional

rods are needed, contact the place of purchase to order. To

shorten the fixture, trim the wires to the desired length,

leave at least 8 to 10 inch of wire in addition to the desired

length and slide any excess rods off the fixture’s wires to

discard. Keep in mind that you must use at least the provided

6 inch rods (M) to hang the fixture. Thread the wires through

the rods and pull the wires until taut before connection the

rods together. Screw bottom rods (M) onto nipples (N) on the

fixture. Screw the nipples of the top rods into swivel posts (I)

of canopy (F). Pull the fixture wires through the top of the

canopy.