Owner's Manual

23
Owner’s Manual EN
Red light turns on the charging
base.
The boundary wire isn’t connected or
boundary wire is broken.
Check that the boundary wire has been
connected correctly to the charging base.
Check there are no breaks in the boundary wire,
especially in the wire ends.
Landroid
®
turns on, but the
blade disc does not move.
Landroid
®
is searching for the charging
base (except that you press the
HOME button to make it go to the
charging base, or the “Border cut”
function is operating).
This is normal, Landroid
®
needs to
recharge, the blade disc does not rotate
while it is searching for the charging base
automatically.
Landroid
®
vibrates.
Blades may be damaged. Check
condition of the blade disc.
Check the blades, and replace them if
damaged.
Remove debris and foreign objects from the
blades and blade disc.
Grass is being cut unevenly
Landroid
®
does not work enough hours
per day.
Add more hours to the mowing time.
Mowing area is too big.
Try decreasing the size of the mowing area or
adding more hours to the mowing time.
Blades are dull.
Change all the blades and screws in order to
balance the bade disc.
The cutting height is set too low for the
length of the grass.
Raise the cutting height and then gradually
lower.
Grass or other object has wrapped
around the blade disc.
Check the blade disc and remove the grass or
other object.
There is a build-up of grass in the blade
disc or motor frame box.
Make sure the blade disc rotates easily. If
need be, you may take off the blade disc and
then remove the debris. See How to Clean.
Your Landroid
®
is inside its
territory and the boundary wire
is connected. But the display
says “Outside working area!
Press “START” to reset”.
The boundary wire ends are clamped
incorrectly.
Reverse the boundary wire ends.
The charging time is far more
than the rated charging time.
Poor connection caused by debris on
the charging strip.
Clean the contact pins located on the
charging base and the charging strip on
Landroid
®
using a cloth.
The charging protection program
has activated due to high or low
temperature.
Place the charging base in a right place or
wait until the temperature has cooled down
or warmed up.
The mower does not charge
There is no power.
Check the LED on charging base is turned
on.
Landroid
®
does not connect correctly
with contact pins while manually
charging.
Try again. Make sure both the charging
pins on the mower touch the centre of the
contact pins on the charging base.
The battery voltage is over 18.85V. This is normal.
Landroid
®
is starting to have
shorter run-times between
charges.
Something is clogged in the blade
disc.
"Take off the blade disc and clean it.
The grass is too high and too thick."
Landroid
®
is shaking heavily.
Check the blade disc and blades, remove
debris and foreign objects from the blades
and blade disc.
The battery may be exhausted or old. Replace battery.
Landroid
®
is not operating at the
correct time.
The clock is not set to the correct
time.
Set the clock to the correct time.
Programmed cutting times for
Landroid
®
are not correct.
Change the time settings for the mower to
start and stop.
Landroid
®
is manually docked in the
charging base.
Press
and then .