User's Manual

COMMUNICATION CERTIFICATION LABORATORY TEST REPORT: 73-6848
FCC ID: NQE-900SSHOPPER
Page 76 of 109
Exhibit 8
If you are using a PC with the supplied Configuration program, the following
instructions will explain how to set up your computer for use with the radio.
Installing the Software
You are now ready to install the software.
1. Turn on your computer and start Windows.
2. Insert the first Install disk in your disk drive.
3. Click the Windows “Start” button, point to “Run”.
4. In the “Open” box type “a:setup” and press Return.
5. Follow the instructions on your screen, inserting the remaining disk(s) when
prompted.
You are now ready to use the Hopper Radio Configuration program.
Performing a Quick Start Radio Test
1. Launch the Configuration program by clicking “Start” then “Programs” then “Hopper
900 Configuration”. You should see the screen as shown below.
2. Select the appropriate COM port to which the radio is connected.