User Guide

ManualsBrandsWoodstock Chimes ManualsFountainsWoodstock Water Bell Fountain

Woodstock

Water Bell Fountain

™

ASSEMBLY INSTRUCTIONS

Thank you for purchasing a Woodstock Water Bell Fountain. This

fountain is designed to combine the relaxing sounds of flowing water

with the peaceful chiming of brass bells. This effect is created by two

floating bells which softly chime against a center cluster of stationary

bells as they are swept around the fountain by an underwater current

created by the pump. The force of this current, and thus the speed of the

floating bells and the frequency of the chiming are completely adjustable.

To personalize your fountain and enhance its visual interest, we

recommend adding small decorative stones or other non-metallic objects

of interest. Make sure that they are cleaned very well before adding them

to the fountain, as small amounts of dirt and grease can damage the

pump. Make sure added objects do not obstruct the movement of the

floating bells or impede the underwater current.

Parts List

First unpack your fountain by removing the box from inside the bowl.

Inside this box you should find:

• The center bell assembly (A), made up of six bells mounted on an

acrylic base with attached flow diverter (D) (only two bells shown)

• Output hose (H)

• Two individual bells with hexagonal center openings (B1 & B2)

• Two floating bells (brass bells mounted to plastic floats - not shown)

Next unpack the bowl with attached pump (C) and power cord (not

shown).

Fountain Assembly

Step 1: Feed the output hose (H) through the hole in the edge of the

acrylic base and attach it to the side of the flow diverter (D) as shown.

Step 2: Make sure that the pump’s flow control is set on “+”. Then, attach

the pump to the flow diverter by inserting the round end of the diverter

(D1) through the center of the bell assembly and into the hole at the top

of the pump (C1).

Step 3: Place bell assembly in the bowl so that each leg is resting in one of

the raised circles at the bottom of the bowl. The pump should be resting

on its rubber feet in the center of the bowl. The end of the output hose

should be oriented so that the water will flow in a clockwise direction

around the bowl.

Step 4: Press the two individual bells onto the six-sided flow diverter stem

at the center of the bell assembly, the larger bell first (B2). You should feel

the bells gently “snap” into place.

Step 5: Make sure the fountain is resting on a level surface. Using distilled

water (highly recommended), fill the bowl approximately 2/3 full or so

that the water level is about one inch below the rim of the bowl. Add

the two floating bells, taking care that they are level when placed in the

water (otherwise they may tip over). If the floats are clover shaped, add

water until the rims of the floating bells are 1” below the rims of the six

fixed bells. If the floats are round, add water until the rims of the floating

Summary of content (2 pages)

PAGE 1
Woodstock Water Bell Fountain™ ASSEMBLY INSTRUCTIONS Thank you for purchasing a Woodstock Water Bell Fountain. This fountain is designed to combine the relaxing sounds of flowing water with the peaceful chiming of brass bells. This effect is created by two floating bells which softly chime against a center cluster of stationary bells as they are swept around the fountain by an underwater current created by the pump.
PAGE 2
bells are even with the rims of the six fixed bells. The fountain will not function properly with too little water, and the pump should never be allowed to run dry. Step 6: Now you are ready to plug in your fountain. Be sure that the power cord loops below the electrical outlet to form a “drip loop.” This will prevent water from running down the cord into the electrical outlet.