USER MANUAL B0931S WOODBRIDGE R Remote Control Instructions Or Email: help@woodbridgebath.com www.woodbridgebath.
WOODBRIDGE R REMOTE CONTROL ILLUSTRATION Content Installation preparation 01. Remote control installation 01 02. Battery installation 01 Usage instruction 01. Remote control illustration 02 02. Rear/Front washing 03 03. Drying/Dryer temperature 04 04. Water pressure adjustment 04 05. Nozzle and air outlet position adjustment 04 06. Energy saving 05 07. Water temperature adjustment 05 08. Seat temperature adjustment 05 09. Night light 05 10. Drying air speed adjustment 06 11.
WOODBRIDGE R REMOTE CONTROL ILLUSTRATION Installation Preparation Remote control installation Remote control holder installation 1: 1. Drill two 6mm (15/64") diameter holes in the wall at a distance of about 130.7mm, (5-9/64") a depth of about 35mm (1-3/8"). 2. Remove the double-sided adhesive tape on the back of the holder. 3. Install an anchor in each of the holes, stick the holder to the wall and secure with screws and then stick the patch with tape.
WOODBRIDGE R REMOTE CONTROL ILLUSTRATION Usage Instruction Remote control illustration Stop/ Energy saver Rear washing/ oscillating washing Front washing/ oscillating washing Indicator light Water increasing Water decreasing Drying/ Dryer temperature 02 Nozzle moving forward Water temperature Half flush Full flush Seat temperature Nozzle moving backward Open/Close the seat Drying air speed Foam button www.woodbridgebath.
WOODBRIDGE R REMOTE CONTROL ILLUSTRATION Usage Instruction Notice : · Only when the user is seated and the buzzer beeps can the functions of front/rear washing and drying be activated. · Please sit backward on the seat for correct washing position and to avoid splashing. · The nozzle will continue to spray for 1-2 seconds after user stands up during washing, so please press “STOP” button before standing up.
WOODBRIDGE R REMOTE CONTROL ILLUSTRATION Usage Instruction DRY|DRYER TEMP ① Short press " " button, the indicator light is on, showing current air temperature, the strong warm air will blow out, and the movement function will be turned on by default. The drying will automatically stop after one cycle or when user departs.
WOODBRIDGE R REMOTE CONTROL ILLUSTRATION Usage Instruction Energy saving ① Long press " once. " button to enter energy saving mode, and the buzzer will beep ② Long press " beep twice. " button again to exit energy saving mode, and the buzzer will · Under energy saving mode, seat temperature is set to Level 1 for energy saving. (Note: If the seat temperature before energy saving is neutral, then it will be neutral as well.
WOODBRIDGE R REMOTE CONTROL ILLUSTRATION Usage Instruction Drying air speed adjustment ① Under drying, short press " " button to switch the wind speed level, and the adjustment is cycled in sequence from 1 to 3 levels. ② Long press " " button to turn on/off the drying movement function. Foam setting ① Short press " " button to activate the foam shield funct ion. ② Long press " " button to turn on pumping quickly until the foam comes out and then release it .
WOODBRIDGE R REMOTE CONTROL ILLUSTRATION Usage Instruction Open the lid by remote control ① Short press " " button to open or close the lid. ② Short press " " button to open or close the seat. ③ Long press " " button to turn on the auto opening function, and the buzzer will beep once. ④ Long press the " " button again to turn off the auto opening function, and the buzzer will beep twice. User code · Radio frequency remote control ① Shut off the power supply of toilet.
WOODBRIDGE R REMOTE CONTROL ILLUSTRATION Usage Instruction Auto deodorization ① Press " " button, and press " " button to turn on the auto deodorization function, and the buzzer will beep once. ② Press " " button again, and press " " button to turn off the auto deodorization function, and the buzzer will beep twice. · Under auto deodorization, the deodorization function will be on when it is detected that the user is seated, and it will automatically stop when the user leaves the seat.
WOODBRIDGE R REMOTE CONTROL ILLUSTRATION Usage Instruction Voice Wakeword Function · Press and hold the " " button and " " button at the same time for more than 3 seconds to turn on or off the voice wakeword function. When the voice function is on,after turning on the voice wakeword function at the same time, users need to send the voice command "hey smart" first, and get the main unit to reply "hi", then the voice function is awakened, and the user can use other voice commands.
Thank you for using WoodBridge products! Or Email: help@woodbridgebath.com www.woodbridgebath.
MODE D’EMPLOI B0931S ® WOODBRIDGE Instructions de la télécommande Ou par Email : help@woodbridgebath.com www.woodbridgebath.
® WOODBRIDGE ILLUSTRATION DE LA TÉLÉCOMMANDE Contenu Préparation de l'installation 01. Installation de la télécommande 01 02. Insertion des piles : 01 Instructions d'utilisation 01. Illustration de la télécommande 02 02. Rinçage arrière/avant 03 03. Température du séchoir/séchage 04 04. Ajustement de la pression de l'eau 04 05. Ajustement de la position de la buse et de la sortie d'air 04 06. Économie d'énergie 05 07. Réglage de la température de l'eau 05 08.
® WOODBRIDGE ILLUSTRATION DE LA TÉLÉCOMMANDE Préparation de l'installation Installation de la télécommande Installation du support de la télécommande 1 1. Percez deux trous de 6 mm (15/64") de diamètre dans le mur à une distance d'environ 130,7 mm, (5-9/64") à une profondeur d'environ 35 mm (1- 3/8"). 2. Retirez le ruban adhésif double face au dos du support. 3.
® WOODBRIDGE ILLUSTRATION DE LA TÉLÉCOMMANDE Instructions d'utilisation Illustration de la télécommande Arrêt/économiseur d'énergie Rinçage arrière / Rinçage oscillant Indicateur Rinçage avant/Rinçage oscillant Température du séchoir/séchage 02 Ouvrir/fermer Vitesse de l'air le siège de séchage Température DEMIE CHASSE de l'eau Buse se déplace vers l’avant Augmentati on de débit Diminution de l'eau Température du siège Buse se déplace vers l'arrière www.woodbridgebath.
® WOODBRIDGE ILLUSTRATION DE LA TÉLÉCOMMANDE Instructions d'utilisation Remarque : • Les fonctions de rinçage et de séchage avant/arrière ne peuvent être activées qu'après que l'utilisateur se soit assis et que l'alarme ait retenti. • Veuillez vous asseoir en arrière sur le siège pour une position de rinçage correcte et pour éviter les éclaboussures.
® WOODBRIDGE ILLUSTRATION DE LA TÉLÉCOMMANDE Instructions d'utilisation TEMPERATURE DU SECHOIR Appuyez brièvement sur la touche " ", l'indicateur s'allume, indiquant la température actuelle de l'air, l'air chaud puissant est soufflé et la fonction de mouvement est activée par défaut. Le séchage s'arrête automatiquement après un cycle ou lorsque l'utilisateur quitte l'appareil.
® WOODBRIDGE ILLUSTRATION DE LA TÉLÉCOMMANDE Instructions d'utilisation Économie d'énergie Appuyez longuement sur la touche " " pour passer en mode économie d'énergie, et le buzzer émettra un bip. Appuyez longuement à nouveau sur la touche " " pour quitter le mode économie d'énergie, et le buzzer émettra deux bips. • En mode économie d'énergie, la température du siège est réglée sur le niveau 1 pour l'économie d'énergie.
® WOODBRIDGE ILLUSTRATION DE LA TÉLÉCOMMANDE Instructions d'utilisation Ajustement de la vitesse de l'air de séchage Pendant le séchage, appuyez brièvement sur la touche " " pour changer le niveau de vitesse du vent, et le réglage se fait en séquence de 1 à 3 niveaux. Appuyez longuement sur la touche " " pour activer/désactiver la fonction de mouvement de séchage. Réglage de la mousse Appuyez brièvement sur la touche " contre la mousse.
® WOODBRIDGE ILLUSTRATION DE LA TÉLÉCOMMANDE Instructions d'utilisation Veuillez ouvrir le couvercle à l'aide de la télécommande Appuyez brièvement sur la touche " " pour ouvrir ou fermer le couvercle. Appuyez brièvement sur la touche " " pour ouvrir ou fermer le siège. Appuyez longuement sur la touche " " pour activer la fonction d'ouverture automatique, et le buzzer émettra un bip.
® WOODBRIDGE ILLUSTRATION DE LA TÉLÉCOMMANDE Instructions d'utilisation Désodorisation automatique Appuyez sur la touche " " et appuyez sur la touche " désodorisation automatique, et le buzzer émettra un bip. " pour activer la fonction de Appuyez à nouveau sur la touche " ", puis sur la la touche " de désodorisation automatique et le buzzer émettra deux bips.
® WOODBRIDGE ILLUSTRATION DE LA TÉLÉCOMMANDE • Remarque. • le buzzer émettra un "BIP" lorsque l'utilisateur appuie sur une touche, ce qui indique que l'unité principale reçoit le signal et effectue l'opération en conséquence. Si l'avertisseur ne retentit pas, cela signifie que l'unité principale ne reçoit pas le signal, veuillez ajuster la direction de la télécommande et réappuyer sur le bouton.
Ou par Email : help@woodbridgebath.com www.woodbridgebath.