User's Manual
Table Of Contents
- Introduction
- Modules RF band support
- Features
- Module Connection Interface
- Environmental Specifications and Certifications
- Environmental Specifications
- Certifications
- Green Product Compliance
- Pin Definitions
- LGA Module Pin Diagram
- LGA Module Pin Definitions
- Electrical Specifications
- Power supply
- Power consumption
- I/O Interface
- USB interface
- UIM interface
- Control interface
- Power-on/ WAKEUP_IN Signal
- WAKEUP_OUT interface
- Reset Signal
- SPI Master Interface
- PCM Interface
- I2S Interface
- I2C Interface
- UART Interface
- ADC Interface
- RF Specifications
- Band support
- Bandwidth support
- RF Transmit Specification
- RF Receiver Specification
- GNSS Receiver Specification
- Software Interface
- Support tools
- USB interface
- Mechanical
- PCBA Form Factor
- Design Guide
- Power supply
- Thermal design
- USB design
- RF connection
- Interference and sensitivity
- GNSS external circuit design
- Reflow
- PCB pad design
- Stencil
- Antenna design requirement
- Labeling and Packaging
- Labeling
- Packing
- MSL level
- Safety Recommendation
47
/
65
Product Technical Specifications
□ Normal □ Internal Use Confidential □ Restricted Confidential
ANT_GNSS pad (Pin9) – GNSS path (optional)
It is recommended that grounds not be present under the surface of the RF pads in the
layout. Details are included below. Layer2 has the same keep out size as Layer1
Figure 19. RF pad layout suggestion