Cut Sheet

ManualsBrandsWiremold ManualsConduitTee Fitting, 800 Series, 4-1/8" Length, 2-3/4" Width, PVC, White

2344SD-2A

Communication

Inserts

5507 Series Faceplate

2344SD-2 Over-the-Raceway Box Application

Catalog No./Item Description/Specifications

2348D Device Box – For use with

2300BACD Divided Raceway. For

mounting standard switches,

receptacles and industry

standard faceplates for

communication devices.

Accepts NEMA Faceplates.

2344D Extra Deep Device Box – For use

with 2300BACD Divided Raceway

when additional depth is required.

For mounting standard switches,

receptacles and industry standard

faceplates for communication

devices. Accepts NEMA Faceplates.

Catalog No./Item Description/Specifications

2344SD-2A Two-Gang Deep Divided Box –

A divided two-gang box for use

with 2300D Series Raceway.

Provides the ability to have both

power and low voltage at a single

point of use. Accepts 5507 Series

Faceplates, Ortronics

TracJack &

Series II Modules, Pass & Seymour

Activate

™

Series Inserts, and

Wiremold Open System

Communication Modules.

The 2300BAC and 2300BACD Series Divided Raceway Box family provides two unique benefits; labor savings with “over-the-

raceway” installation and Sure-Snap

device boxes. The 2348D and 2344D “over-the-raceway” design eliminates cutting the

raceway base to mount boxes. The base snaps on anywhere along the raceway. The Sure-Snap integral device box of the

2344SD-2A combines aesthetics with labor savings. 5507 Series Faceplates, Pass & Seymour Activate Inserts, Wiremold Open

System Communication Modules and Ortronics Series II and TracJack Modules snap directly into the Sure-Snap Device Box,

eliminating the need for additional faceplates. The single-gang boxes accept standard NEMA faceplates.

4 3/4"

(121mm)

4 3/4"

(121mm)

(76mm)

4 7/8"

(124mm)

1 3/4"

(44mm)

2 1/4"

(57mm)

4 3/4"

(121mm)

(76mm)

2 3/4"

(70mm)

Sure-Snap® Device Boxes for 2300BACD Divided Series Raceway Ordering Information

Note: Not for use with NEMA Faceplates. CM-EPLA End

Plates are required when using Wiremold Open System

communication modules and Pass & Seymour

Activate

inserts. S2-EPL End Plates are required when using

Ortronics

Series II inserts. To mount Ortronics

TracJack modules, use 5507-4TJ or 5507-6TJ Faceplates.

Sure-Snap

Device Boxes for 2300BACD Divided Series Raceway