Use and Care Manual

Clean outside of unit as
necessary by wiping with
a dry, soft cloth; for stub-
born stains, use a warm,
damp cloth.
To reset the filter once a new HEPA filter is installed:
a. Plug the unit back in with the front cover off
b. Turn on the unit
c. Locate the filter reset button on
the display panel
d. Press and hold the filter reset
button for 3-5 seconds. A short beep
will be heard and the light should turn off.
e. Place the front panel back on the unit
and the air cleaner is ready to use
The REPLACEMENT FILTER INDICATOR
will signal when to replace/clean the HEPA
Filter. The clean/replacement period will vary
depending on the hours of usage, air quality
and location of the unit. Please note that the
carbon filter needs to be changed every
3 months or as needed.
NOTE: Do not wash and reuse Carbon Filter,
it will not work effectively.
There are two separate filters: Washable
HEPA and Carbon Pre Filter.
The Washable HEPA filter should normally
be washed every 1/2 year but maximum
6 times equivalent to 3 years of usage.
Then it should be replaced.
After changing/cleaning HEPA, mark the
filter at designated check boxes on filter
edge (see image below), and push reset
button on inside of unit – See number
5 instruction to the right.
For best performance, change the
Carbon Filter every three months.
Unit Cleaning
12