www.windsterhood.com LINER SERIES User’s Manual WS-69TB30 / WS-69TB36 (22”) WS-69TB42 / WS-69TB48 (22”) WS-69TS30 / WS-69TS36 (18”) WS-69TS42 / WS-69TS48 (18”) NOTE: PLEASE INSPECT HOOD IMMEDIATELY UPON RECEIVING. CLAIM OF DAMAGE AFTER 7 DAYS OF DELIVERY WILL BE DENIED. This unit is designed for indoor residential use only. DO NOT USE OVER A WOOD GRILL OR MOUNT IN OUTDOOR ENVIRONMENT. Please read this operation manual thoroughly before using your range hood.
TABLE OF CONTENTS 1 Table of Contents Safety Information .............................................................. 2 – 3 Content Checklist ..................................................................... 4 Measurements ........................................................................... 5 Preparation ............................................................................... 6 Installation .................................................................................
2 SAFETY INFORMATION SAFETY INFORMATION TO REDUCE THE RISK OF A FIRE, ELECTRICAL SHOCK, AND/OR INJURY OBSERVE THE FOLLOWING: x x x x Unit is intended for indoor residential use only. If you should have questions, contact the manufacturer at the address or telephone number listed in the warranty. In case the unit should need to be cleaned or repaired, switch power off at service panel and lock service disconnecting means to prevent power from being switched on accidentally.
SAFETY INFORMATION 3 TO REDUCE THE RISK OF FIRE, OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL DEVICE. x Regardless of heat level, never leave any surface materials unattended while operating an open flame. x Always turn hood ON when cooking at high heat or when flambéing food (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambé). x Depending on amount of usage, clean ventilating fans and filters frequently.
4 CONTENT CHECKLIST CONTENT CHECKLIST 1. CONTENTS INCLUDED a. (1) 120V, 60Hz, 4A WS-69 series (30”/36”/42”/48”) hood assembly b. (1) User’s manual c. (2) 35W GU10 Halogen lights d. (1) 6” to 7” conversion collar(30”/36”) (1) 8” conversion collar (42”/48”) e. (2) Baffle filters w/ handles & (2) stainless steel filler (30”/36”) f. (3) Baffle filters w/ handles & (2) stainless steel filler (42”/48”) g. (1) 1-3/4” x 3/4” Rectangular Light Fixture removal tool h.
MEASUREMENTS 5
6 PREPARATION PREPARATION 1. BEFORE YOU START **DO NOT INSTALL IF DAMAGED** **RETURN OR EXCHANGE WILL BE DENIED IF INSTALLED** a. Be sure you have all the content of your purchase and required tools for this installation. b. Installation may take at least 1 to 2 hours from start to finish. c. Plan to use as few elbows or turns as possible for more efficient air flow. d. Collar size may need to be increased if utilizing a long duct run. e. At least 12” of vertical duct is required before any turn.
INSTALLATION 7 INSTALLATION 1. DUCTED INSTALLATION **DO NOT INSTALL CLOSER THAN 29” ABOVE COOKING SURFACE** a. Make sure all preparation steps are completed. b. Determine where you would like to mount the hood. c. Lift the unit up flush against the wall. d. Be sure the unit is leveled and parallel. e. Using the screws and washers provided, tightly secure the unit against the wall and the cabinet frame. NOTE: Install additional screws through the back of the unit if necessary. f.
8 INSTALLATION DIAGRAM
OPERATION & FEATURES 9 OPERATION & FEATURES 1. EASY ACCESS KNOB CONTROL a. b. Knob 1 – Light ON / OFF Knob 2 – Speed i. 1 – Low speed ii. 2 – Medium speed iii. 3 – High speed 2. BAFFLE FILTERS a. (2) 14-3/8” x 12-3/4” baffle filters and (2) fillers (30” / 36”) b. (3) 14-3/8” x 12-3/4” baffle filters and (2) fillers (42” / 48”) 3. REMOVING THE BAFFLE FILTERS 1 Slide the baffle filter into the hood. ˕ 2 Push the baffle filter upward. ˕ 3 Slide the baffle filter toward you.
10 OPERATION & FEATURES
OPERATION & FEATURES 11
12 CLEANING & MAINTENANCE CLEANING & MAINTENANCE WARNING!!! To prevent the possibility of a fire and explosion, do not use flammable liquids or solvents to clean the unit or any of its parts. Check to make sure all power sources are disconnected before servicing or taking unit apart for cleaning. Please thoroughly clean the unit weekly as stainless steel can rust under certain condition or by improper cleaning. 1. RANGE HOOD a.
TROUBLESHOOTING 13 TROUBLESHOOTING WARNING!!! Check to make sure all power sources are disconnected before starting any troubleshooting. Safety gloves and glasses should be worn when working on the unit. Serious injury or death may occur if safety precautions are not followed. WS-69 Series Light Issue (One light not turning on) 1. Replace defective GU10 Fixture with new fixture. Filters loose 1. Ensure inside springs are properly expanded Control Knobs not working correctly 1.
14 PARTS LIST / REPLACEMENT PARTS LIST / REPLACEMENT 30” 36” 42” # Description # Description 1 6” round collar 6 Control knob 2 Hood body assembly 7 Motor 3 Halogen / LED lights 8 Oil tray 4 Light cover 9 Baffle filters 5 Capacitor 48”
WARRANTY / CONTACT US 15 WARRANTY / CONTACT US LIMITED WARRANTY Windster Hoods Inc. warrants its product against defects in material or workmanship as follows: Labor: For a period of one (1) year from the date of purchase, if the product is determined to be defective, Windster will attempt to repair the product, at its option, at no charge. After the warranty period, customer must pay for all labor charges. During the "labor" warranty period there will be no charge for any work done on the purchased model.
16 WARRANTY / CONTACT US WHAT IS NOT COVERED BY MANUFACTURE WARRANTY 1. Damages resulting from any of the following: a. Improper installation or maintenance b. Any repair, modification, alteration or adjustment not authorized by the manufacturer or an authorized service dealer c. Misuse and/or accidents d. Incorrect electric current, voltage or power supply e. Improper setting of any control (Pressing multiple selections at the same time) f. 2.