User guide

3. Before rethreading the sight retaining ring into

the sight body, firmly snug the insert completely

in the front sight body or damage to the insert

will occur. Replace the retaining ring and tighten

it firmly against the insert.

SIGHT INSERT REMOVAL —

1. Remove the sight retaining ring from the

front sight body by turning the knurled end

counterclockwise (Figure 5).

2. Gently pick the insert out with a small

screwdriver, being careful to not damage

either the insert or the sight body.

The front sight body is adjustable for windage and

also features a small bubble level to indicate when

the rifle is perfectly level, helping to eliminate

unwanted canting.

CAUTION: BEFORE MAKING ANY VERTICAL

ADJUSTMENT OF THE ELEVATOR, BE SURE TO

LOOSEN THE SIGHT DISK A HALF-TURN. FAILURE

TO DO SO WILL RESULT IN DAMAGE TO THE SIGHT.

SIGHT ADJUSTMENT INSTRUCTIONS

FRONT SIGHT WINDAGE

(HORIZONTAL ADJUSTMENT) —

1. To adjust the front sight for windage loosen the

left locking screw, moving the sight body with the

right adjustment screw, then retightening the

locking screw.

2. Move the front sight body to the left to move

the point of bullet impact to the right. Each

index mark on the front sight represents 5

minutes of angle.

REAR SIGHT WINDAGE

(HORIZONTAL ADJUSTMENT) —

Rear sight windage adjustments are made by turning

the windage knob. The mechanism is built on a