User's Manual

9
10
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
Powering up a Wilson Electronics
Signal Booster
1. Never point the front of a directional Outside Antenna toward the Inside
Antenna. Refer to Figures above.
2. Ensure that both the Outside Antenna cable and the Inside Antenna
cable are connected to the Signal Booster and the connections are
tight before powering up the Signal Booster.
3. Plug the power supply into the Signal Booster input marked “6V DC”
(carefully, to avoid damaging the center pin) and then into a surge
protected AC Power Strip.
4. If the Signal Booster does not have a green light, please refer to pages
10-14.
5. Using multiple Signal Boosters in one installation could cause
interference to the cell tower.
6. Contact Wilson Electronics Technical Support Team with any questions at
866-294-1660 or email [e-mail]. Technical Support
hours are Mon.- Fri. 7 am to 6 pm MST.
Channel Select Directions for 800 & 1900 MHz
Note: For a list of channel options see tables on page 15.
If you know your desired channel setting, press or hold down the 1.
yellow CH Select button until that channel UL center frequency and
bandwidth are displayed on the LCD screen. Refer to pages 11 &
12 for further instructions about the LCD screen display numbers.
Refer to page 15 for Uplink and Downlink Channel Selection Chart.
Signal Booster
Outdoor
Antenna
Inside Panel
Antenna
Figure 1
Figure 2
CORRECT INSTALLATION
Point antennas away from each other
INCORRECT INSTALLATION
Never point antennas toward each other
Inside Panel
Antenna
Signal Booster