Assembly Instruction

T
ools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (6) E12
Candelabra Base Bulbs 60W Maximum(Not Include)
.
Estimated Assembly Time: 30-40 minutes
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture.
We strongly recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
BB
DD
STEP 2 - Attach Mounting Screws, Lock Washers
and Hex Nuts to Mounting bracket.
Line up a set of holes on the
Mounting bracket (EE) and Holes
on the ceiling canopy.
Thread Mounting Screws (DD)
into the holes on the
Mounting bracket (EE). Pass Lock
Washers and thread Hex
Nuts onto the Mounting
Screws (DD) .
Hand tighten until snug.
A.
Ceiling
Canopy
EE
DD
Figure 1
EE
Outlet Box
CC
A Fixture Body x1
A(Fixture Body)
STEP 1
-
Install Rods to Fixture Body
A.
Thread the power cord to the Middle Rods ,
fix the Middle Rods with
the fxiture body
then the same
to connect the
other pieces of Rods,
finally fix the Canopy
with the Rods.
Rod
Assembly Instruction Sheet