Owner`s manual

Installing Your Heater
12
WARNING: Carbon monoxide is a poisonous,
combustible gas formed by incomplete
combustion. It is colorless, odorless and
tasteless. Depending on the length of exposure
and the amount inhaled, carbon monoxide can
cause –
• Dizziness
• Headache
• Nausea
• Bodily injury (brain damage)
• Death by asphyxiation
If you encounter or suspect that carbon
monoxide is present, get fresh air at once and
seek medical attention immediately.
WARNING: Improper installation, adjustment,
alteration, service or maintenance can cause
injury or property damage. Refer to this manual.
For assistance or additional information, consult
a qualified installer, service agency or the gas
supplier.
Operating Your Heater
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
LIGHTING THE PILOT
A. This appliance is equipped with an ignition device which
manually lights the pilot.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
C. WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance or strike a match.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions
• If you cannot reach your gas supplier, call the fire
department.
D. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
E. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
underwater.
OPERATING INSTRUCTIONS
1. STOP! Read the safety information above.
2. Check that gas supply to the heater is on.
3. Push in gas control knob slightly and turn clockwise
to "OFF".
4. Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas, STOP!
Follow "C" in the safety information above on this label. If
you don't smell gas, go to the next step.
5. Push in gas control knob slightly and turn
counterclockwise to "PILOT/IGN" and depress for five (5)
seconds.
6. Release control knob pressure and turn clockwise to
"OFF".
7. Depress control knob while OFF, then turn back to
PILOT/IGN. This should cause the spark from the piezo
igniter to light the pilot gas. Keep control knob depressed
for ten (10) seconds before releasing. If pilot does not
light, repeat steps 5 through 7.
8. Press the control knob down slightly and rotate
counterclockwise to "ON". Release the knob.
Gas control knob
is shown in
"OFF" position