Installation & Assembly

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture
and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a
clear area. Take care not to lose any small parts necessary for
installation.
3. Thread the two mounting screws about 1/4” into the pre-drilled
holes in the mounting plate spaced the same distance apart as the
holes in the canopy (A).
4. Attach the mounting plate to the Junction Box with the two
Junction Box Screws as shown. The side of the mounting plate
marked "GND" must face out.
The junction box is not
included.
5. Attach the canopy (A) to the top center pipe nipple of the shade
(C), by turning it clockwise until tight.
6. Install the light bulbs in accordance with the fixture specifications
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
7. Please see the Fig 1.1 (round frame Top View). Loosen the tie
crystal cluster of cord and organize appropriate. Raise the acrylic
plate(D), round frame (E) to the bottom of the shade (C), aligning
the center hole with pipe nipple and screw it with the finial (G).
8. Raise the end grapnel of the crystal cluster(F) hooked the inside
ring of round frame(E).
9. While holding the shade assembly towards the ceiling, connect the
electrical wires as Shown in Fig.2, making sure that all wire nuts
are secured. You may have to wrap the connections with electrical
tape. If your outlet has a ground wire (green or bare copper),
connect the fixture ground wire to it. Otherwise connect fixture’s
ground wire directly to the mounting plate with the green screw
provided. After wires are connected, tuck them carefully inside the
Junction Box.
10. Raise the shade assembly onto the junction box, aligning screws on
mounting plate with mounting holes in canopy (A) and lock it
securely with the ball nut (B).
Your installation is now complete. Return power to the junction
box and test the fixture.
Fig.1
C
B
D
E
A
F
G
F
Inside
ring
Fig 1.1
Round
frame(
E)
Fig.2
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
(Ground)
Page 1 of 1
ASSEMBLING & INSTALLATION INSTRUCTIONS
CEILING MOUNT FIXTURE

Summary of content (1 pages)