Installation Guide

4.
OpentherequiredACandDCconduitdrillguidesaccordingtotheconduitsusedintheinstallation:
Thedrillguidesarelocatedatthebottomandsidesoftheenclosure,eachwithtwosizes:¾''and1''.
Opentherequireddrillguides,takingcarenottointerferewithanyoftheinternalcomponents.Itis
recommendedtouseaUnibitdrill.
Figure 14: Safety Switch drill guides
NOTE
Unused conduit openings and glands should be sealed with appropriate seals.
Mounting the Inverter
Theinverterissuppliedwithamountingbracketkit:
Figure 15: Mounting bracket
NOTE
Make sure the mounting surface or structure can support the weight of the inverter.
CAUTION!
SolarEdge inverters and power optimizers can be installed at a minimum distance of 50 m/ 164 ft from
the shoreline of an ocean or other saline environment, as long as there are no direct salt water splashes
on the inverter or power optimizer.
ATTENTION!
Les onduleurs SolarEdge peuvent être installés à une distance minimum de 50m de la ligne d'eau de
l'océan ou autre environnement salin, tant qu'il n'y a pas d'éclaboussements d'eau salée directs sur
l'onduleur.
1. Determinetheinvertermountinglocation,onawall,studframingorpole.Itisrecommendedto
mounttheinverterinalocationprotectedfromdirectsunlight.
-Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.0
26
Mounting the Inverter