Overview of Primary Product (SST1400-100)

ManualsBrandsWhite Rodgers ManualsHVAC SuppliesElectronic Air Cleaner Prefilter For SST1400-100, Emerson 14, Grainger 14

7. With the cabinet installed, the air cleaner can now be

wired to electrical input source.

WARNING

Installation of this unit must comply with localInstallation of this unit must comply with local

Installation of this unit must comply with local

electric codes or other applicable codes.electric codes or other applicable codes.

electric codes or other applicable codes.

Review and understand local codes prior to instal-Review and understand local codes prior to instal-

Review and understand local codes prior to instal-

lation.lation.

lation.

Failure to do so could result in serious personalFailure to do so could result in serious personal

Failure to do so could result in serious personal

injury or death.injury or death.

injury or death.

8. An air cleaner unit with no air flow monitor requires

electrical wiring through the furnace controls. Con-

nect wiring to the furnace control terminals (EAC-H)

for power, (EAC-N) for neutral and connect metal

frame of EAC to ground.

If the air cleaner unit has an air flow monitor, it must be

connected to 120 VAC 60 Hz. A 20 amp circuit is more

than adequate. If an air flow monitor is not installed but

is required for operation, order Air Flow Kit F859-

0381. If a power cord is required, order F97-0019.

9. Remove junction box cover and install the required

bushing into the 3/4 in. Knock out. With the supply

voltage turned off, route three (3) wires into junction

box for connections. (See Fig. 17.)

Insure all wires are clamped, wire connectors prop-

erly installed and grommets used to prevent wire

abrasion.

Vertical

Section

Wood Block

Tape All

Joints

Figure 16

Hot

Neutral

Grounding

Conductor

Front View

Figure 17

Cabinet

Pre-Filters

Handle

Contact

Button

Contact

Button

Collecting Cells

Power Pack

Figure 18

WIRING INSTRWIRING INSTR

WIRING INSTR

UCTIONSUCTIONS

UCTIONS

11. With the cabinet Installed, reinstall pre-filter(s) and

collecting cell(s) (Figure 18).

NOTE: The contact button and handles on the cell

must be facing you and ionizing wires must be on the

air intake side.

12. Install the power pack as follows:

Engage the lip on lower inside edge of power pack in

the flange on cabinet and carefully close the power

pack, making sure that the electrical connector prongs

on the power pack enter the slots in the socket on

cabinet. When the power pack is fully in place, engage

the latch and snap it closed.

Side Edge of

Power Pack

Male Plug

Female Plug

Cabinet

Press to Close After

Latch is Engaged

Latch

To Engage

Engage Lip on Lower Inside Edge

of Power Pack in Flange.

Figure 19 Installing Power Pack

10. If this unit has an electrical cord, the cord has a

grounding type plug with a third (grounding) pin. This

plug will fit only into a grounding type power outlet. If

the proper type of outlet is not available, contact

qualified personnel to install a proper outlet. Do not

alter the plug in any way.

▲

ARNINGARNING

ARNING

To reuce the risk of electric shock, The power cordTo reuce the risk of electric shock, The power cord

To reuce the risk of electric shock, The power cord

must be connected to an appropriate outlet. Do notmust be connected to an appropriate outlet. Do not

must be connected to an appropriate outlet. Do not

alter the plug in any way.alter the plug in any way.

alter the plug in any way.