Installation guide

ElectrlcaJ Shock Hazard
Plug into a grounded 3-prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
if codes permit and a separate
ground wire is used, it is
recommended that a qualified
electrician determine that the ground
path is adequate.
Do not ground to a gas pipe.
Check with a qualified electridan if
you are not sure range is grounded.
Do not have a fuse in the neutral or
ground circuit.
A 120-volt, 60-Hz, AC-only, 15 amp,
fused electrical circuit is required. A
dine-delay fuse or circuit breaker is
recommended, it is recommended
that a separate circuit serving only
this range be provided.
Electronic ignition systems operate
within wide voltage limits, but
proper grounding and polarity are
necessary, in addition to checking
that the outlet provides 120-volt
power and is correctly grounded, the
outlet must be checked by a qualified
electrician to see if it is wired w,ith
correct polarity.
The wiring diagram is included in the
literature package.The wiring
diagram can also be found on the
back of the range.
NOTE:The metal chassis of the range
must be grounded in order for the
control panel to work. if the metal
chassis of the range is not grounded,
no keypads will operate. Check with
a qualified electrician if you are in
doubt as to whether the metal
chassis of range is grounded.
Recommended ground
method
For personal safety, this range is
equipped with a power supply cord
having a 3-prong ground plug.To
minimize possible shock hazard, the
cord must be plugged into a mating
3@rong, ground-type outlet,
grounded in accordance with the
National Electrical Code, ANSI/NFPA
70 - latest edition s`or CSA Standard
C22.1, Canadian Electrical Code, Part
1,- latest edition _-_and all local
codes and ordinances. If a mating
outlet is not available, it is the
personal responsibility and
obligation of the customer to have a
properly grounded, 3-prong outlet
installed by a qualified electrician.
power
supply
cord_- /
3_pri _
ground plug \ .
grouna
prong
3-prong
ground-type outlet
Q
Copies of the standards listed may be obtained from:
*National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts, 02269
**CSA International
8501 East PleasantValley Road
Cleveland, Ohio 44131-BB7B
start...
With range in Mtchen.
1[] Put on safety glasses and
gloves. Remove shipping materials,
tape and protective film from range.
Keep cardboard bottom and shipping
base under range. Remove oven
racks and parts package from inside
oven.
-"cardboard
corners
spacers
2[] Take 4 cardboard corners from
the carton. Stack one cardboard
corner on top of another. Repeat with
the other two corners. Place corners
lengthwise on the floor in back of
range so corners will support outer
side edges of range as shown.
Excessive Weight Hazard
Use two or more people to move and
install range.
Failure to do so can result in back or
other injury.
3M Firmly grasp the range and
gently lay it on its back on the
cardboard corners.
4M Pui[ cardboard bottom and
shipping base firmly to remove from
range.
5M Use an adjustable wrench to
loosen the leveling legs 1-1/2 turns.
Place cardboard or hardboard
in front of range. Stand range back
up onto cardboard or hardboard.