Installation guide

ievei
fiat-Made screwdriver
3/8" drive ratchet
3/8"' and 5/16"' nut driver
, hand or eHectrb drHi
,channei Hock pliers
safety giasses
gioves
measuring tape or ruier
wood floors: 1/8" drHi bit
concrete/ceramic floors: 3/16"' carbide-
tipped masonry drHi bit (Hammer may
be needed for anchors.}
ftoopmounted
anti-tip bracket
Not shown:
literature pack
alastic anchors
(#10 x 1-1/2"}
Brackets must be securely mounted to
sub-floor.Thickness of flooring may require
longer screws to anchor bracket to sub-floor.
Longer screws are available from your local
hardware store,
38" (91.4 cm)
cooktop height
with leveling
legs lowered
1-1/2 turns
30-3/4" (78.1 cm}
cooktop width
J
22-1/2"
(57.1 cm}_
30" (76.2 cm)
width
The cooktop sides of the siide-in
range fit over the cutout edge of
your countertop.
if you have a square finish (fiat)
countertop and the opening width is
30-3/8" (77.2 cm), no countertop
preparation is required.
Formed front-edged countertops:
Must have moided edge shaved fiat
1/4" (0.64 cm} from each front corner
of opening.
TiMecountertops may need trim cut
back 1/4" (0.64 cm) from each front
corner and/or rounded edge
flattened.
if countertop opening width is
greater than 30-3/8" (77.2 cm), adjust
the 1/4" (0.64 cm) dimension.
Countertop must be ievei. Piace ievei
on countertop, first side to side; then
front to back. if countertop is not
ievei, range wili not be ievei. Oven
must be ievei for satisfactory baking
conditions.
Formed or flied countertop trimmed 1/4"
(0.64 crn} back at front corners of countertop
opening.
Cooktop sides of range
fit over edges of
countertop opening.
f