Use and care guide

24
CLEANING THE FILTERS IN THE WATER INTAKE HOSE
1. Close the water tap and unscrew the intake
hose.
1
2
2. Thoroughly clean the mesh lter at the end of
the hose using a brush.
3. At this point, manually unscrew the intake hose
from the back of the washer dryer. Using pliers,
extract the mesh lter from the valve on the back
of the washer dryer and clean it.
4. Re-insert the mesh lter. Reconnect the intake
hose to the water tap and the washer dryer. Do
not use tools to connect the intake hose. Open
the water tap and check to make sure that all the
connections have been tightened properly.
2
1