Use and care guide

15
EN
2. Press button “Dry only” to dry without a wash
cycle.
3. Select the type of drying desired, by pressing
the “Dryness level” button for automatic
drying levels or the «Drying time» button to
set drying time.
- Automatic drying with selectable levels:
In automatic drying mode, the washer dryer
machine dries the laundry until the set
level of dryness is reached. Pressing button
“Dryness level” once automatically selects the
highest drying level available for the selected
programme. Press the button again to reduce
the drying level.
The following levels are available:
Wardrobe : laundry is completely dry and
ready to be put away in the wardrobe without
ironing.
Hanger : laundry is left slightly damp to
minimise creasing. Garments must be hung to
air dry completely.
Iron : garments are left reasonably damp to
make ironing easier.
- Timer drying mode:
To set a specic drying time, press the “Drying
time” button until the led for the desired time is
illuminated. Values from 180 to 40 minutes are
settable
N.B.: always allow a cooling down period after
drying before opening the door.
5. USING THE CORRECT AMOUNT OF
DETERGENT. Pull out the tray and pour
detergent into the relative compartments
as described in “Detergent dispenser”. This is only
necessary when using a wash only or a wash +
dry programme.
6. DELAYING THE START OF A PROGRAMME. To
set a programme to start at a later time, see the
section “Programmes and Options”.
7. STARTING A PROGRAMME.
Press the START/PAUSE button. The
corresponding indicator light is illuminated,
the door locks and the door open symbol
extinguishes. To change a programme while
a cycle is in progress, press START/PAUSE to
pause the washer dryer (the START/ PAUSE
lamp ashes amber slowly); then select the
required cycle and press START/PAUSE again.
To open the door while a cycle is in progress,
press START/PAUSE; the door may be opened
if the symbol lights. Press the START/PAUSE
button again to resume the programme from
where it was paused.
8. CANCELLING A RUNNING PROGRAMME IF
NECESSARY
Press and hold the button until the washer
dryer stops.
If the water level and temperature are low
enough, the door unlocks and may be opened.
The door remains locked if there is water in
the drum. To unlock the door, switch the
washer dryer on and select the SPIN & DRAIN
programme. The water is emptied and the door
unlocks at the end of the programme.
9. SWITCHING THE WASHER DRYER OFF AT THE
END OF A PROGRAMME.
At the end of the programme, the door open
light will switch on. The door can only be
opened when the symbol lights. Check that
the door open light is on, then open the door
and remove the laundry.
Press to switch the washer dryer o. To save
energy, if the washer dryer is not switched
o manually with the button, it turns o
automatically approximately 30 minutes after
the end of the programme.
Leave the door ajar to let the interior of the
washer dryer dry.