Dispensing Guide

2
4. Dispense water.
NOTE: While dispensing water, the digital display will count
down how much water remains to be dispensed, according to
the volume you selected. The flow of water will automatically
stop once the desired volume has been dispensed.
� Press a sturdy glass against the dispenser paddle.
or
� Place the glass below the water dispenser and press
Measured Fill, under Dispense, for hands-free dispensing.
5. To stop dispensing before the selected volume has been
dispensed, remove the glass from the dispenser lever or press
the Measured Fill button a second time.
NOTE: If you stop dispensing before the desired volume has
been dispensed, the digital display will continue to show how
much water remains to be dispensed. The display will turn off
after 1 minute of inactivity.
6. To select a new volume or start dispensing the same volume
again, you must first finish dispensing the selected volume, or
turn off the Measured Fill feature (either by waiting 1 minute so
it will automatically turn off or by pressing Ice/Water “Back” to
manually turn it off) and then turn it back on.
TO DISPENSE ICE
IMPORTANT:
� If the ice cubes are hollow or have an irregular shape, it could
be because of low water pressure. See “Water Supply
Requirements” in the Owner’s Manual.
� Ice travels from the ice storage bin through the dispenser chute
to the dispenser. To turn off the ice maker, see “Ice Maker and
Storage Bin” in the Owner’s Manual.
� The dispenser may continue to make noise and ice may
continue to dispense for several seconds after releasing the
dispenser button or paddle.
The word “Ice” appears on the display screen when either crushed
or cubed ice is selected.
For crushed ice, cubes are crushed before being dispensed. This
may cause a slight delay when dispensing crushed ice. Noise from
the ice crusher is normal, and pieces of ice may vary in size.
NOTE: When changing from crushed to cubed, a few ounces of
crushed ice will be dispensed along with the first cubes.
1. Select the desired type of ice. To switch between cubed ice and
crushed ice, press Ice/Water.
WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the dispenser paddle. Hold the
glass close to the dispenser opening so ice does not fall
outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to the
paddle to activate the ice dispenser. Pressing hard will not
make the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds after
removing the glass from the dispenser paddle. The dispenser
may continue to make noise for a few seconds after
dispensing.
Temperature-Controlled Drawer
IMPORTANT: This control sets the temperature for only this
drawer. It does not set the temperature for, or turn off cooling to the
refrigerator or freezer compartments.
Use the full-width drawer to store large party platters or deli trays,
or use a drawer organizer to store smaller items such as yogurt,
juice boxes and lunch meat for easy access.
Temperatures have been preset for the storage of: Cold Drinks,
Meats/Cheeses, Assorted Items and Fruits/Vegetables. These
preset temperatures cannot be adjusted.
Press Select to toggle through the temperature settings. The icon
will illuminate when it is selected.
Crisper and Crisper Cover
To remove the crisper(s) cover:
1. Remove crisper drawers.
2. Holding the glass insert firmly with one hand, press up in center
of glass insert until it rises above the plastic frame. Gently slide
the glass insert forward to remove.
3. Lift the cover frame up and remove it.
To replace crisper(s) cover:
1. Fit back of cover frame into supports on side walls of the
refrigerator and lower the front of the cover frame into place.
2. Slide rear of glass insert into cover frame and lower front into
place.
3. Replace crisper drawers.
CRISPER DRAWER REMOVAL AND REPLACEMENT
To remove and replace the drawers:
1. Grasp the handle at the bottom of the drawer and slide the
drawer straight out to the stop. Lift the drawer off the bottom
guide.
2. Replace the drawer by placing it on the bottom drawer guide
and pushing it past the drawer stop into position.
EASYSLIDE BIN
A shallow storage compartment with glass lids which slide from
side to side is located below and in front of the crisper drawers.
NOTE: This compartment is not temperature or humidity
controlled, so it is not recommended for storing leafy vegetables.