Owners Manual

23
REPLACE DRAWER FRONT
1. Pull out the drawer glides until they are full extended.
2. Style 1: Bottom Release Lever
� Push up on the lever at the bottom of the drawer glide
bracket to open. Insert the drawer front bracket into the
drawer glide bracket and release the lever.
Style 2: Bottom Screws
� Lower the loosened screws in the top of the door front into
the upper notches in the drawer glide.
� Align the holes in the bottom of the drawer glides.
� Replace two screws removed previously and tighten all
four screws.
NOTE: It helps if one person holds the drawer glides steady
while another person aligns the drawer front and inserts the
screws into the notches.
3.
Reconnect Wiring (if applicable)
� Align the two ends of the wiring connector and push them
together until you hear a click sound and feel the tabs snap
into place on the connector.
� Gently pull on the wiring connection to ensure the wiring
connection is completely seated. Replace the wiring cover.
NOTE: The wiring connection must be complete for the
drawer temperature control to operate.
4. Replace the drawer bins onto the drawer glides.
Remove and Replace Freezer Drawer Front
Depending on the width of your door opening, it may be necessary
to remove the freezer drawer front to move the refrigerator into
your home.
IMPORTANT:
� If the refrigerator was previously installed and you are moving
it out of the home, before you begin, turn the refrigerator
control Off, and unplug the refrigerator or disconnect power.
Remove food and any adjustable door or utility bins from
doors.
� Two people may be required to remove and replace the
freezer drawer
Tools Needed: 1/4" hex driver
REMOVE DRAWER
Front Style 1 & 2
1. Open the freezer drawer to its full extension.
2. Loosen the two screws at the top, inside the drawer front (one
on the left-hand side and one on the right-hand side) that
fasten the drawer front to the drawer glides as shown below.
3. Remove the 2 screws at the bottom, inside the drawer front
that fasten the drawer front to the drawer glides as shown
below.
4. Lift up on the drawer front to release the plastic studs from the
drawer glide bracket slots as shown below.
Style 1 Style 2
A. Drawer glide bracket slots A. Drawer glide bracket slots
5. Slide the drawer glides back into the freezer.
Front Style 3
1. Open the freezer drawer to full extension.
2. Loosen the four screws attaching the drawer glides to the
drawer front as shown below.
NOTE: Loosen screws three to four turns. Keep the screws in the
drawer front.
A. Four Bracket screws
3.
Lift drawer front upward and off the screws.
REPLACE DRAWER
Front Style 1 and 2
1. Pull out the freezer drawer glides to their full extension.
2. Holding the drawer front by its sides, align the two plastic
studs, located at the bottom, inside the drawer front, with the
drawer glide bracket slots.
NOTE: It helps if one person holds the drawer glides steady
while another person aligns the drawer front and inserts the
studs into the slots.