Owners Manual

4
Style 2: Stainless Steel
DO USE DO NOT USE
� Soft, clean cloth � Abrasive cloths
� Paper towels or newsprint
� Steel-wool pads
� Warm, soapy water with a
mild detergent
� Abrasive powders or
liquids
� Ammonia
� Citrus-based cleaners
� Acidic or vinegar-based
cleaners
� Oven cleaners
� For heavy soil, use only a
manufacturer’s approved
stainless steel cleaner and
polish
� Abrasive powders or
liquids
� Ammonia
� Citrus-based cleaners
� Acidic or vinegar-based
cleaners
� Oven cleaners
� Abrasive cloths
� Paper towels or newsprint
� Steel-wool pads
NOTES:
� If unintentional contact does occur, clean plastic part with a
sponge and mild detergent in warm water. Dry thoroughly with
a soft cloth.
� Avoid exposing stainless steel appliances to caustic or
corrosive elements such as high-salt, high-moisture, or high-
humidity environments. Damage due to exposure to these
elements is not covered under the warranty.
� Just because a cleaner is a liquid does not mean it is
nonabrasive. Many liquid cleansers formulated to be gentle on
tile and smooth surfaces still damage stainless steel.
� When cleaning stainless steel, always wipe in the direction of
the grain to avoid cross-grain scratching.
� Citric acid permanently discolors stainless steel. To avoid
damaging the finish of your stainless steel refrigerator:
Do not allow these substances to remain on the finish:
• Mustard
• Tomato juice
• Marinara sauce
• Citrus-based sauces
• Citrus-based products
Condenser Cleaning
WARNING
Explosion Hazard
Risk of Fire or Explosion due to Puncture of Refrigerant
Tubing;
Follow Handling Instructions Carefully.
Flammable Refrigerant Used.
There is no need for routine condenser cleaning in normal home
operating environments. If the environment is particularly greasy
or dusty or there is significant pet traffic in the home, the
condenser should be cleaned every 6 months to ensure maximum
efficiency.
1. Unplug refrigerator or disconnect power.
2. Remove the base grille.
3. Use a vacuum cleaner with a soft brush to clean the grille, the
open areas behind the grille, and the front surface area of the
condenser.
4. Replace the base grille when finished.
5. Plug in refrigerator or reconnect power.
NOTE: If you are unable to clean the condenser, please call for
service.
Changing the Light Bulb
IMPORTANT: The lights in both the refrigerator and freezer
compartments use LED technology that do not need to be
replaced. If the lights do not illuminate when the door or drawer is
opened, call for assistance or service. Refer to the Quick Start
Guide for contact information.
The lighting system in this appliance may consist of:
� Sealed LED modules
� LED Bulbs
� Incandescent Bulbs
� Or a combination of the above.
If an LED bulb does not illuminate when the refrigerator and/or
freezer door is opened, replace with like bulb following this
procedure:
1. Unplug refrigerator or disconnect power.
2. Remove the light shield (on some models).
� Remove the hardware holding the light shield in place.
� Top of the refrigerator compartment - Slide the light shield
toward the back of the compartment to release it from the
light assembly.