Use and Care Guide

F# E# or F## E## code

other than as described

above appears in display

System error code. Touch POWER once to clear the code. Then touch POWER

again to restart washer. If code appears again, call for service.

Unplug washer for 30 seconds; then plug back in.

Washer making error

beeps

Door has not been opened and

closed for at least three cycles.

This code may occur when the washer is rst turned on.

Open and close the door to clear the display.

Washer beeps when Start/

Pause is touched

Door not closed. Close the door completely.

Clean Washer LED ashing

at end of wash cycle

(on some models)

The washer has run 30 wash cycles

and is indicating a reminder to run the

Clean Washer with affresh

cycle.

Run the Clean Washer with affresh

cycle. If the Clean Washer

with affresh

cycle is not turned on, the LED will stop ashing

at the end of a wash cycle after running three more regular

wash cycles. After 30 more wash cycles are completed, the

Clean Washer with affresh

LED will again ash at the end of

a wash cycle as a reminder.

TROUBLESHOOTING

If you experience Possible Causes Solution

Error Code Appears in Display (for 2- and 3-digit displays) (cont.)

“rL” (remove load)

appears in display

Load detected in drum during Clean

Washer with affresh

cycle.

Remove items from washer drum and restart Clean Washer

with affresh

cycle.

First try the solutions suggested here or visit our website at www.whirlpool.com/owners

(in Canada www.whirlpool.ca/owners) for assistance and to possibly avoid a service call.