USER SLIDEOUT RANGEHOODS M A N U A L LABEL HERE IMPORTANT: Please ensure that you read through this user manual prior to installation and use. This manual contains important information to ensure optimal performance and keep you safe. Please retain your proof of purchase, as this will be required in the event that you require warranty service. Remember to retain this manual for future reference.
CONTENTS WARNING & SAFETY INFORMATION 3 OPERATING INSTRUCTIONS 4 MAINTENANCE & TROUBLESHOOTING 6 INSTALLATION & DUCTING 7 CONTACT DETAILS Cover 2
WARNING & SAFETY INFORMATION TECHNICAL GUIDANCE DO’S & DONT’S • There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels. • Do not flambe under the rangehood. • Do not remove or inspect the filters whilst the hood is in operation. • There is a fire risk if cleaning is not carried out in accordance with the instructions. • You must read the details concerning the method and frequency of cleaning.
OPERATING INSTRUCTIONS 600 SLIDEOUT RANGEHOOD IMPORTANT: To operate the unit, ensure that the power is turned on and the front visor is fully extended. This will provide access to the light and speed controls. FAN SPEED LOW/OFF/HIGH switch - Located on the right hand side of the unit. This unit features 2 speed settings; single line indicate low speed, double lines indicate the high speed.
OPERATING INSTRUCTIONS 900 SLIDEOUT RANGEHOOD CONTROL PANEL IMPORTANT: To operate the unit, ensure that the power is turned on and the front visor is fully extended. FAN SPEED OFF/LOW/MEDIUM/HIGH SLIDING SWITCH - Located on the right hand side of the control panel. This unit features 3 speed settings; single line indicate low speed, double lines indicate the medium speed & triple lines indicate high speed.
MAINTENANCE & TROUBLESHOOTING GENERAL MAINTENANCE Ensure that the power to the unit is switched off prior to cleaning the unit. The surface should only be cleaned with warm soapy water and a soft non-abrasive cloth. In coastal environments and humid areas more frequent cleaning is required to maintain the finish. FILTERS - 600 Slideout Rangehood The 600 Slideout Rangehood unit is supplied with Aluminium filters designed for ducted installations.
INSTALLATION & DUCTING 600 SLIDEOUT RANGEHOOD 10A plug fitte ø120 28 * *Model Dependent 900 SLIDEOUT RANGEHOOD 10A plug fitte * *Model Dependent NOTICE: All measurements shown are to be used as a guide only, cutout dimensions should be taken from physical product.
INSTALLATION & DUCTING IMPORTANT: Before handling the rangehood during the installation, it is recommended that you remove the filter to prevent damage. The image to the left, illustrates the minimum height from the hob surface to the underside of the rangehood. Electric hob - 600mm Gas hob - 650mm. NOTICE: IF THE INSTRUCTIONS FOR THE GAS HOB SPECIFY THE GREATER DISTANCE, THIS HAS TO BE OBSERVED. ANY INSTALLATION ABOVE 750MM WILL COMPROMISE PERFORMANCE.
INSTALLATION & DUCTING DU CT ED RECIRCUL ATIN G DUCTED OPTION (if your model permits) RE-CIRCULATING OPTION (if your model permits) 1. 2. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Remove the filter. Optional - replace the 80mm front rail with the 40mm front rail Make sure that the internal switch is in ducted position. (see above) Determine the most efficient path for the ductwork, minimise bends and keep the length of the ductwork to a minimum.
NOTES 10
NOTES 11
Version 1.8 We are committed to ongoing research and development. Every effort has been made to ensure all information in the user manual is correct at time of going to print. Dimensions should be used as a reference only and actual dimensions should be taken from the physical product.