Installation Install Oven Under Cooktop

ManualsBrandsWhirlpool ManualsSingle Electric Wall OvensWOS72EC0HV

CUTOUT DIMENSIONS FOR OVENS INSTALLED UNDER COOKTOP

IMPORTANT: Observe all governing codes and ordinances. Cooktop must be approved for use over an oven. See cooktop Installation

Instructions for cutout dimensions. Center the cooktop cutout over oven cutout.

To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor,

delaminate, or sustain other damage. This oven has been designed in accordance with UL and CSA International and complies with

the maximum allowable wood cabinet temperatures of 194°F (90°C).

Approved Built-In Oven and Electric Radiant/Coil Cooktop Combinations

See product website for a list of cooktop models approved for use above select wall-oven models.

NOTE: For undercounter installation, it is recommended that the junction boxes for the oven and cooktop be located in the adjacent

right or left cabinet. A 1" (2.5 cm) minimum diameter hole should have been drilled in the upper rear right or left corner of the side wall

surface to pass the appliance cable through to the junction box.

A. 24" (61 cm) cabinet depth

B. 25" (63.5 cm) countertop depth

C. Recommended oven and cooktop junction box locations

D. Allow 5/8" (16 mm) for oven trim to overlap on each side

E. 27

" (70.5 cm) minimum cutout height

F. 36" (91.4 cm) from cabinet base to countertop

G. 4

" (11.7 cm) maximum from cabinet base

H. See Cutout Dimensions chart

I. 31

" (79.7 cm) from top of countertop to bottom of cutout

Cutout Dimensions

Oven Size Oven Cutout Dimension

24" (61 cm) 22

" (57.2 cm)

27" (68.6 cm) 25

" (64.8 cm)

30" (76.2 cm) 28

" (72.4 cm)

36" (91.4 cm) 34

" (87.6 cm)

W11097840A

Summary of content (12 pages)

PAGE 1
CUTOUT DIMENSIONS FOR OVENS INSTALLED UNDER COOKTOP IMPORTANT: Observe all governing codes and ordinances. Cooktop must be approved for use over an oven. See cooktop Installation Instructions for cutout dimensions. Center the cooktop cutout over oven cutout. To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate, or sustain other damage.
PAGE 2
Approved Built-In Oven and Induction Cooktop Combinations B A C C I D F E G H A. B. C. D. E. F. G. 24" (61 cm) cabinet depth 25" (63.5 cm) countertop depth Recommended oven and cooktop junction box locations Allow 5/8" (16 mm) for oven trim to overlap on each side 273/4" (70.5 cm) minimum cutout height 36" (91.4 cm) from cabinet base to countertop 45/8" (11.7 cm) maximum from cabinet base. If dimension “F” is greater than 36" (91.
PAGE 3
Approved Built-In Oven and Gas Cooktop Combinations C B A D D E F I N E G J H K M L O A. 24" (61 cm) cabinet depth B. 1" (2.5 cm) clearance to bottom of countertop C. 25" (63.5 cm) countertop depth D. Recommended oven junction box locations E. 1" (2.5 cm) clearance to cabinet F. 273/4" (70.5 cm) minimum cutout height G. Allow 5/8" (16 mm) for oven trim to overlap on each side H. 36" (91.4 cm) from cabinet base to countertop I. 313/8" (79.7 cm) from top of countertop to bottom of cutout J.
PAGE 4
Notes 4
PAGE 5
DIMENSIONES DE CORTE PARA HORNOS INSTALADOS BAJO LA SUPERFICIE DE COCCIÓN IMPORTANTE: Respete todos los códigos y las ordenanzas vigentes. Se debe aprobar el uso de la superficie de cocción sobre un horno. Para obtener las dimensiones de corte, vea las Instrucciones de instalación de la superficie de cocción. Centre el corte de la superficie de cocción sobre el corte del horno.
PAGE 6
Combinaciones de horno integrado y superficie de cocción de inducción aprobadas B A C C I D F E G H A. B. C. D. E. F. G. H. I. Profundidad de armario de 24" (61 cm) Profundidad del mostrador de 25" (63,5 cm) Ubicaciones recomendadas para el horno y la caja de conexiones Deje 5/8" (16 mm) para que el borde del horno quede solapado a cada lado Altura mínima del corte: 273/4" (70,5 cm) 36" (91,4 cm) desde el armario base al mostrador 45/8" (11,7 cm) máximo desde el armario base.
PAGE 7
Combinaciones de horno integrado y superficie de cocción a gas aprobadas C B A D D E F I N E G J H K M L O A. B. C. D. E. F. G. Profundidad de armario de 24" (61 cm) 1" (2,5 cm) de distancia en la parte inferior del mostrador Profundidad del mostrador de 25" (63,5 cm) Ubicaciones recomendadas la caja de conexiones 1" (2,5 cm) de distancia del armario Altura mínima de corte: 273/4" (70,5 cm) Deje 5/8" (16 mm) para que el borde del horno quede solapado a cada lado H.
PAGE 8
Notas 8
PAGE 9
FOUR INSTALLÉ SOUS LA TABLE DE CUISSON : DIMENSIONS POUR L’OUVERTURE À DÉCOUPER IMPORTANT : Observer les dispositions de tous les codes et règlements en vigueur. La table de cuisson doit être homologuée pour une utilisation au-dessus d’un four. Pour les dimensions de l’ouverture à découper, voir les instructions d’installation de la table de cuisson. Centrer l’ouverture à découper pour la table de cuisson par rapport à l’ouverture découpée pour le four.
PAGE 10
Combinaisons four encastré/table de cuisson à induction (produits homologués) B A C C I D F E G H A. Profondeur de placard 24" (61 cm) B. Profondeur du plan de travail 25" (63,5 cm) C. Emplacements recommandés pour le boîtier de connexion du four et de la table de cuisson D. Prévoir 5/8" (16 mm) pour le chevauchement de la garniture du four, de chaque côté E. 273/4" (70,5 cm) min. de hauteur d’encastrement F. 36" (91,4 cm) entre la base du placard et le plan de travail G.
PAGE 11
Combinaisons four encastré/table de cuisson à gaz (produits homologués) C B A D D E F I N E G J H K M L O A. B. C. D. E. F. G.