Installation Instruction

6" (15.2 cm) vent system = 73 ft (22.2 m) total. If the existing vent is round, a rectangular-to-round transition

piece must be used. In addition, a rectangular 3" (7.6 cm)

extension vent between the damper assembly and rectangular to

round transition piece must be installed to keep the damper from

sticking.

ASSISTANCE

Call your authorized dealer or service center. When you call, you

will need the microwave oven model number and serial number.

Both numbers can be found on the model and serial number

plate, which is located behind the microwave oven door on the

front frame of the microwave oven.

If you need additional assistance, call us at our toll-free number

or visit our website listed in the User Guide.

Replacement Parts

If any of the installation hardware needs to be replaced, call us at

our toll-free number listed in the User Guide.

Following is a list of available replacement parts. You will need

your model number located on the front facing of the microwave

oven opening, behind the door.

■ Damper assembly

■ Mounting plate

■ Mounting Screw Kit (includes parts A through G in “Parts

Supplied” in the “Tools and Parts” section)

A B

C D

6 ft (1.8 m)

2 ft

(0.6 m)

A. Two 90° elbows = 20 ft (6.1 m)

B. 1 wall cap = 40 ft (12.2 m)

C. 1 rectangular-to-round transition piece = 5 ft

(1.5 m)

D. 2 ft (0.6 m) + 6 ft (1.8 m) straight = 8 ft (2.4 m)