Owner's Manual

7
LED DISPLAY AND SETTINGS
When you select a cycle, its default settings will light up
and the Estimated Time Remaining (for Automatic Cycles)
or actual time remaining (for Manual Cycles) will be
displayed.
Automatic Cycles are Heavy Duty, Normal, Bulky, Casual,
Delicates, Towels, and Sanitize. Manual Cycles are Quick
Dry and Timed Dry. The Steam Cycle is Steam Refresh.
Touch along the bottom of the display to adjust settings.
Touch “+” or “–” with Manual Cycles to increase or
decrease the length of a Timed Dry or Quick Dry cycle.
See “Cycle Guide” for available settings on each cycle.
Not all settings are available with all cycles.
Cycle Status Lights
The indicator bar at the top of the display will let you
know what stage of the drying cycle is in process.
For more information on each stage, see “Cycle Status
Indicators.”
Temp
When using Manual Cycles, you may select a dry
temperature based on the type of load you are drying.
Use the warmest setting safe for the garments in the
load. Follow garment label instructions.
NOTE: Automatic Cycles use a preset temperature that
is not adjustable.
Dryness Level
You may adjust the Dryness Level on Automatic Cycles
(except for the Sanitize cycle), if desired.
NOTE: Dryness Level is for use with Automatic Cycles
only.
Damp Dry Signal
Touch to select the Damp Dry Signal. When selected, a
series of beeps will sound when the load is damp, but
not completely dry. This will allow you to take clothes
out of the load that do not need to dry completely.
This option is available on Heavy Duty, Normal, Bulky,
Casual, Towels, and Delicates cycles. The Damp Dry
Signal is selected as a default for the Bulky cycle, as
a reminder to manually reposition bulky loads midway
through the cycle.
Wrinkle Shield
™
Option
If you will be unable to remove a load immediately,
touch Wrinkle Shield
™
to add up to 140 minutes of
periodic tumbling to help reduce wrinkling. You may
select the “With Steam” setting to add a short steam
cycle after 60 minutes to help smooth out wrinkles.
4 5
OPTIONS
Use to select available options for your dryer. Not all
cycles and options are available on all models.
Steam (on some models)
Touch to activate the Steam option, which adds steam
at the end of the cycle before cool down.
EcoBoost
™
Option
Touch to activate the EcoBoost
™
option, which
allows you to increase your energy savings by using
a slightly lower heat level. This may increase dry
times somewhat.
Static Reduce (on some models)
Touch to add the Static Reduce option to selected
Automatic cycles. The dryer will automatically tumble,
pause, and introduce a small amount of moisture
into the load to help reduce static. This option adds
approximately 8 minutes to the total cycle time.
Drum Light
Touch to turn the LED drum light on or off. The light
will also turn on when the door is open, and turn off
automatically after about 5 minutes.
Cycle Signal
Use this to turn the signal indicating the end
of a drying cycle on or off.
NOTE: You may also turn off the tones that sound
when a feature, setting, or option is touched. Touch
and hold Cycle Signal for about one second to turn
sounds on or off.
Control Lock
Use to lock the controls of the dryer and avoid
an accidental change in cycle options or preferences
during a drying cycle.
NOTE: The Control Lock function may be enabled
when recovering from a power failure. To unlock the
control, touch and hold CONTROL LOCK for at least
3 seconds.
B
E
A
D
C
F