Dimensions Guide

3. Move the door strike

Using a T25

screwdriver, remove the two screws securing

the door strike to the door frame of the dryer. Rotate the strike

180° and attach to the opposite side of dryer door frame with

the two screws removed earlier, as shown.

†

TORX, T20, and T25 are registered trademarks of Acument Intellectual Properties, LLC.

DOOR REVERSAL (OPTIONAL)

The following instructions are for models with round and

square-shaped doors.

#2 Phillips screwdriver

Min. 8" (203 mm) long

TORX

, T20

and T25

†

screwdrivers

Tools needed:

1. Disconnect wiring from door

Using a Phillips screwdriver, remove middle screw in hinge.

Disconnect wiring. Tuck wiring into opening.

REVERSE DOOR SWING: ROUND-SHAPED DOOR

2. Remove door from dryer

IMPORTANT: If the protective lm has not yet been removed

from the dryer, peel the lm from the dryer door before

proceeding.

Using a T25

screwdriver, remove the four screws securing

the door hinge to the dryer and lift the door up and out to

remove. Place the door on a soft towel or other non-scratch

surface.

DOORS WITH ELECTRICAL WIRING:

ALL DOORS: