Installation guide

f—
3: Tighten couplings
Using pliers, tignten the couplings with additional
two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling
can result.
{f—
4. Attach long hose to “Y”
connector and tighten couplings
One end of the long hose has a
wire mesh strainer inside the coupling. Attach this end to the
“Y” connector. Attach washer cold inlet hose to other side of
“Y” connector. Screw on coupling by hand until it is seated
on connector. Using pliers, tighten the couplings an additional
two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling can result.
5. Attach long hose to dryer fill valve
and tighten coupling
St
NSO
ON
AN
TON
(oY
\
ve
Remove protective cap from
water inlet valve. Attach other end
of long hose to fill valve at bottom of dryer
back panel. Screw on coupling by hand until it is seated on
fill valve connector. Using pliers, tighten the couplings an
additional two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling
can result.
f
6. Turn on cold water faucet
Check that the water faucets are turned on.
{
7. Check for leaks
spe
Check for leaks around “Y” connector, faucet, and hoses.
13