Installation Guide

1. Remove door from dryer

IMPORTANT: If the protective ﬁlm has not yet been

removed from the dryer, peel the ﬁlm from the dryer door

before proceeding.

Using a T25

screwdriver, remove the 4 screws securing the

door hinge to the dryer and lift up and out to remove the door.

Place the door on a soft towel or other non-scratch surface.

Reinstall the 4 screws in the holes.

Reverse door swing round-shaped door curved glass – double handle

2. Move the door strike

Using a T25

screwdriver, remove the 2 screws securing the

door strike to the door frame of the dryer. Rotate the strike

180° and attach to the opposite side of dryer door frame

as shown.

Remove inner door from outer door

Position the door with the inside of the door facing up.

Using a Phillips screwdriver, remove the 10 screws securing

the inner door to the outer door. Lift off the inner door and

set aside.

4. Remove hinge and latch

Using a T25

screwdriver, remove the 3 screws securing the

latch plate and latch backing plate and the 5 screws holding

the hinge assembly in place.

Hinge

Latch